GE DBVH520 Owner's Manual page 15

ge.com
STEP-BY-STEP INSTRUCTIONS (cont.)
Reassemble Door Assembly (cont.)
19.After reversing door, there will be a mismatch between the outer door and
the inner doon
Make sure that the handle part of the outer door is opposite the hinge,
as shown.
\ 20.Turn the door over and fasten the outer door to the inner door using
the 6 large tapping screws (#10).
i
i
Move Strike Bracket
"/ 1!!/I \ 21. Using a puttg knife or ang other flat tool, remove the S plastic screw caps
located on the drger where the door will be installed and install them on
the opposite side.
.X
22. Switch the strike bracket and its cover on the opposite side bg removing
the then reinstall both the side. screws;
on
opposite
Partiallg
Inserted ®
Screw
Tighten
All
Reinstall Door Assembly
2&The door is now readg to be installed on the drger. To ease this step,
the hinge has kegholes that allow a partiallg fastened screw to be used
as a hook
Partiallg fasten a screw to the uppermost screw hole Hook the door on the
partiallg fastened screw
Fasten the hinge bg installing the other 4 screws and tightening the partiallg
fastened screw above
15