Advertisement
Available languages
Available languages
Installation
Instructions
INSTALLING THE REFRIGERATOR
REFRIGERATOR LOCATION
• Do not install the refrigerator where the temperature
will go below 60°F (16°C)because it will not run often
enough to maintain proper temperatures.
• Do not install the refrigerator where the temperature
will go above IO0°F (37°C)because it will not perform
properlg.
• Install it on a floor strong enough to support it fullg
loaded.
CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections.
Standard Depth
Models
Sides
1/8" (3 mm)
Top
1" (25 mm)
Back
1" (25 mm)
REMOVETOP CAP (onsomemodels)
• IMPORTANTNOTE:This refrigerator is 34-1/2" deep.
Doors and passagewags leading to the installation
location must be at least 36" wide in order to leave
the doors and handles attached to the refrigerator
while transporting
it into the installation location.
If passagewags are less than 36", the refrigerator
doors and handles can easilg be scratched and
damaged. The top cap and doors can be removed
to allow the refrigerator to be safelg moved indoors.
Start with Step A.
• If it is not necessarg to remove doors, skip Step A.
Leave tape and all packaging on doors until the
refrigerator is in the final location.
• SKID REMOVAL:Tilt refrigerator to each side to
remove skid.
• NOTE:Use a padded hand truck to move this
refrigerator. Place the refrigerator on the hand truck
with a side against the truck. We stronglg recommend
that TWO PEOPLEmove and complete this installation.
[]
Locate and remove the two Phillips head screws on
the top of the refrigerator. Remove the two screws
on each side at the rear of the top cap. Lift off and
remove top cap.
[]
Remove the fresh-food door. Refer to Steps i through
3 of "Reversing the Door Swing" section.
[]
Remove the bottom freezer drawer. Refer to
"Removing Freezer Drawer" section.
[]
Move refrigerator to the installation location.
REMOVETOP CAP (cont.) (onsomemodels)
REINSTALL DOORS, DRAWERS AND TOP CAP
[]
Carefully lower the door onto the center hinge.
Reinstall top hinge. NOTE: Ensurethe door is properly
aligned to the case top to avoid readjustment of the
door during top cap reinstallation.
[]
Place cap over the top of the refrigerator. Reinstall
the original screws in the top and back of the cap.
[]
Reinstall the bottom freezer drawer. Refer to
"Replacing the Freezer Drawer" section.
A
Top Hinge
[]
CONNECTING THE REFRIGERATOR
TO THE HOUSE WATER LINE
(icemaker and dispenser models}
A cold water supply is required for automatic
icemaker operation. If there is not a cold water
supply, you will need to provide one. See Installing
the Water Line section.
NOTES:
• Before making the connection to the refrigerator,
be sure the refrigerator power cord is not plugged
into the wall outlet.
• If your refrigerator does not have a water filter, we
recommend installing one if your water supply has
sand or particles that could clog the screen of the
refrigerator's water valve. Install it in the water line
near the refrigerator. If using GESmartConnect _"
Refrigerator Tubing Kit, you will need an additional
tube (WX08X10002) to connect the filter. Do not cut
plastic tube to install filter.
16
Advertisement
