GE Profile WPDH8850 Owner's Manual & Installation Instructions page 17

Installation Instructions
UNPACKING THE WASHER
WARNING:
Recycle ordestroy thecarton
and plastic bagsafter t hewasher is unpacked. Make
materials inaccessible tochildren. Children m ightuse
them forplay. Cartons covered withrugs, b edspreads
orplastic sheets can become airtight chambers causing
suffocation.
1. Cut and remove the top and bottom packaging straps.
2. While it is in the carton, carefully lay the washer on its
side. DO NOT lay the washer on its front or back.
3. Turn down the bottom flaps-remove all base packaging,
including the cardboard, styrofoam base and styrofoam
tub support (inserted in center of base). Save the stacking
brackets located on the styrofoam pad that covered
the top of the washer.
NOTE: If you ore instolling o pedestol, proceed to
the instollotion instructions thot come with the pedestol,
4. Carefully return the washer to an upright position and
remove the carton.
5. Carefully move the washer to within 4 feet (122 cm)
of the final location.
6. Remove the following from the back side of the washer:
4 bolts
4 plastic spacers (including rubber grommets)
4 power cord retainers
7. Remove the shipping bolt. Insert plug into shipping
bolt hole.
s S
J
j
NOTE: Foilure to remove the shipping broces con couse
the wosher to become severely unbolonced,
Sove oil bolts for future use,
NOTE: If you must transport the washer at a later date,
you must reinstall the shipping support hardware to prevent
shipping damage. Keep the hardware in the plastic bag
provided.
17