Installation Instructions - GE WSLP1100 Owner's Manual & Installation Instructions

Installation
Instructions
WSLS1100
Washer
WSLP1100 WSLM1100
I ffyou have questions,call 800-GECARES or visit our Website at: www.GEAppliances.com
I
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT - S ,,e these
instructions tot local inspector's use.
• IMPORTANT
- Obse,,e ,ll
governing codes and ordinances.
• Note to Installer
-
Be sure
to leave these
instructions with tile Consumer.
• Note to Consumer - Keep
these instructions
tot fllture reference.
• Skill level - Installation of this appliance requires
basic mechanical skills.
• Completion time - 1 hour
• Proper installation is tile responsibili V of tile
installer.
• Product failure due to improper installation is not
covered under the Warranty.
• Note
_ This appliance
must be
properly
grounded, and electrical setwice to the washer must
conli)rm with local codes and ordinances and tile
latest edition of the National Electrical Code,
ANSI/NFPA 70.
WASHER LOCATION
_sher must be installed on firm flooring to minimize
vibration during spin cycles. Concrete flooring is best,
but wood base is sufficient providing floor sui)port
meets FHA standards. X4'asher should not be installed
on tugs or exposed to the weather.
Install or store where it will not be exposed to
temperatm'es below fl'eezing or exposed to tile
weather.
ELECTRICAL
This appliance must be supplied with tile voltage and
frequency indicated on tile rating plate (located on
tile back of tile washer), and connected to an
individual, propedy gro/mded branch circuit, protected
bv a 15 or 20 amp circuit breaker or time-delay fllse.
If the washer is plugged into the (hTer's 115 w)lt outlet,
then tile dryer needs to be on a dedicated circuit.
PLUMBING
• WATER PRF]SSURF]--Must be 10 p.s.i, minimum to
150 p.s.i, maximum dynamic pressure measm'ed at
faucet.
• WATER TEMPERATURE--Household water
heater should be set to deliver water at 120 ° to 150°F
(50 ° to 66°C) IN THE _;__SHER when HOT wash is
selected.
SHUT-OFF VALVES--Both hot and cold shut-off
wdves (faucets) should be supplied.
DRAIN--Water may be drained into a standpipe or
set tub. The discharge height MUST NOT BE LESS
THAN 30" nor more than 8' above tile base of tile
washeL Tile standpipe must be 1½" minimum inside
diameter and must be open to tile atmosphere.
RACK INSTALLATION
• Ensure washer is centered between tile rack sides.
PARTS SUPPLIED
[_ Water Hoses (2)
[21Drain t lose
[_ Cable Tie
[_ Rubber X_;ashers (4)
TOOLS REQUIRED
Pliers
9