GE Profile DPGT750 Owner's Manual And Installation Instructions page 10

Summary Screen
GEApplia r_ces, corn
About the
Drying
Options
Touch the OPTIONS pad on the Touch Screen
to select drying options. After selecting any drying
options, press OK to save your setting.
Delay Start
Touch the DELAY START pad repeatedly to set a
del W time of up to 12 hours. The countdown time
will be shown in the display.
Extended Tumble
Minimizes wrinldes by adding approximately
20 minums of no-heat rambling after clothes are
din Touch EXTENDED TUMBLE to mrn the
fe.ature on or off: If set, the Extended Tumble time
will not be included in the cycle time shown in the
display. The d,yer will signal for the fi_t 6 minums
during Extended Tumble.
Alerts you that the cycle is complete. The clothes
should be removed when the beeper goes off so
wrinkles won't set in. Touch END OF CYCLE
SIGNAL to select the volume or to mrn the
beeper ore The new volume will be saved as the
defiuflt setting.
OPTIONS
) DELAY START IHOUR l
) EXTENDED TUMBLE _,_ ]
)END OF CYCLE SIGNAL I_1))) ]
(on somemodels)
OPTIONS
[ DELAY ] [ EXTENDED ]
START TUMBLE
_DAMP SIGNAL I
_END OF CYCLE S,GNAL _}))i
Adjusting the
7Vme Settings
You can adjust file time setting for the &Y cycle,
delay start and extended ramble times. Touch the
TIME pad on the Summa_ T Screen; then choose
the time you wish to adjust.
To change the dry cycle time, select CYCLE TIME;
dlen use file arrows to select more or less drying
time. If the Cycle Time is changed, the dryness
sensor will be turned ore
To change the delay start or extended tumble time,
select DELAY TIME or EXTENDED TUMBLE;
then follow the instructions in the About the
Drying Options section.
ADJUST TIME SETTINGS
[C C'E""E I[OE'AY" !
EXTENDED TUMBLE ]
About the
Cycle Status
Screen
10
After you press START, a Cycle Smms screen will
appear to indicate what cycle the &Ter is in and
the time remaining in the cycle.
DRYING - The &Ter is sensing the moisture level
of the load.
SENSING - The &Ter is detemdning if the correct
&Tness level h_s been reached.
COOL DOWN - The load is chT and may be
removed (the dcyer will continue to blow cool air
for up to 5 minutes).
EXTENDED TUMBLE - The load is dry and may
be removed (the drum will continue to mrn
without heat for up to 20 minutes).
CYCLE STATUS
CHANGE SETTINGS
m
m
DRYING