GE J2B918 Installation & Owner's Instructions page 39

installationof therange.
Read these instructions oomplete/y and carefully.
IN THECOMMONWEALTH OFMASSACHUSETTS
::Ji:: This product must be installed by a licensed
plmnber or gas fitter,
::Ji:: When using ball type gas shut-off valves, they
shall be the T-handle type.
?_:A flexible gas connector, when used, must not
exceed 3 teet.
BEFORE Y OUBEGIN
Installation of this range must conform with local codes, or in the absence of local codes,
with the National Fuel Gas Code, ANSI Z223.1/NFPA.54, latest edition. This range has been
design-certified by CSA International according to ANSI Z21.1, latest edition.
_s Mth any appliance using gas and generating
heat, there are certain sateD' precautions you
should tollow. D_u will find these precautions in
the ImportantSafetylnformation secdon in the
fl'ont of this manual. Read them careflfllv.
IMPORTANT'. OBSERVE A LLGOVERNING CODES
AND ORDINANCES.
NOTE" Thisappliance must be properly grounded
IMPORTANT'.Save these Ibstructions for the local electrical
lbspector# use.
NOTE TO INSTALLER: Leave these instructions with the
applianceafter installation is completed
NOTE TO CONSUMER: Keep this Owner# Manual and
Installation Instructions for future use.
SERVICER: Theelectncal d iagramis/n an envelope attached
to thebackof therange.
FOR YOUR SAFETY
Do not store or use combustible materials, gasoline or other flammable vapors and liquids in the
vicinity of this or any other appfiance.
ff you smell gas:
[] Open windows.
] Don't touch electrical switches.
[] Extinguish any open flalne.
[] hnlnediatelv call yore', ooas, s upplie_:
ELECTRICAL REOUIREMENTS
CAUTION: FOR PERSONAL SAFETY,
DONOTUSE AN EXTENSION CORD WITHTHIS
APPLIANCE R EMOVE H OUSE FUSE OROPEN CIRCUIT
BREAKER BEFORE BEGINNING I NSTALLATION.
This appliance must be supplied with the proper
voltage and
fl'equency,
and connected to an
individual, properly grotmded circuit, protected
by a circuit breaker or time-delay filse, as noted
on the rating plate.
Wiringmustconformto National E lectncCodes.
If the electric service provided does not meet the
above specifications, have a licensed electrician
install an approved outlet,
Because range temfinals are not accessible after
range is in position, flexible service conduit or cord
must be used.
39