GE J2B918 Installation & Owner's Instructions page 16

Usingthe clock and timer.
Not all features are on all models.
Make sure the clock is set to flTe
correct time of day.
ToSet the Clock
The clock must be set to the correct time
of elm fin" the autonmtic oxen timing
flmcfions to work properly. The time of day
cannot be changed
during a timed
baking
or sel6cleaning c) cle.
[] Touch the
CLOCK pad.
[] Touch the nmnber pads.
Touch the numl)er pads the same way you
read them. For example, to set 19:34, touch
the nmnber
pads I, 2, 3 and 4in that order;
If mmfl)er pads are not touched within one
mimKe after you touch the
CLOCK
pad, the
display reverts to the original setting. If this
hapi)ens, touch the
CLOCK
pad and reenter
the time of day.
[] Touch the
START
pad tmfil the time
of dax shows in the display. This ente_
the time and starts the clock.
Tocheckthetime ofdaywhenthedlspby /s
showing otherinformation, s /knp/y t ouchthe
CLOCK pad Thetimeof dayshowsuntilanother
padis touched
i i ili i
The timer is a minute timer only.
The CLEAR/OFF pad does not affect
the time_
To Set the Timer
Thetl_nerdoesnot control oven operations.
Themaxl/numsetting on the timer is 9 hours
and 59 minutes.
[]
[]
Touch the KITCHENTIMERON/OFF
pad.
Touch the numl)er pads tmtil the
alllOtlnt ot tiI/le veil %3111t shows in
the display. The maMmum nmnber
of minutes that can be entered is 60.
To set additional time, you will need
to set it by hems and minutes.
For example, to enter 1 hour and
30 minutes, touch
I, 3andO
in
that order;
If you
make a mistake, press the KITCHEN TIMER
ON/OFF p adandbeginagain.
I , [] Touch the
START
pad. _dter _ressing
the STARTpad, SET disappeax_; this
tells you the time is cotmting down,
although the display does not change
tmtil one minute has passed.
[] X_q_en the timer reaches :00, the
control will beep 3 times fi_llowed b_
one beep every 6 seconds tmtil the
KITCHEN TIMER ON/OFF pad is touched.
The 6 second tone can be canceled
by following
the steps in the Special features of your oven
control section under Tones at the End of a Timed
Cycle.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by touching
the KITCHEN TIMER ON/OFF pad; then touch
the nulnber pads tmtil the time you want
appea_s in the display.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time
by
touching the
KITCHENTIMERON/OFF
pad
and then touching the numl)er pads to
enter the
new
time
VOII %3111t,
ToCancel the Timer
Touch the KITCHENTIMERON/OFF pad twice.
Power Outage
lf a flashing tinTe Isin thedisplay, y ouhave
expenenced a power failure. Reset the
clock.
To reset the clock, touch the CLOCK pad,
Enter the correct time of clay by touching
the appropriate nmnber pads. Touch the
START
pad.
16