Step 3: Install The Cooktop; Step 4: Conect Cooktop To Gas; Step 5: Install The Cooktop Backguard - GE Monogram ZGU48N4G Installation Instructions Manual

Installation
P1"ofessiollal Gas Cooktops
3
Msta]]
the
Cooktop
• Lower tim cooktop into tim opening. Make
sure tim cooktop is evenly seated and sut>
ported. A side fl'ame gasket will seal tim
cooktop to tim countertop.
• "L" brackets with screws are provided to
secure tim cooktop to the countertop or to
adjacent cabinetry.
-Alternate screw hole locations on tile sides
of tim cooktop allow for varying thicknesses
of countertops or side cleats.
• Select tim bracket location, secure tim
bracket to tim cooktop with 2 screws.
• Drive one screw through tim bottom of tim
"g" bracket and into countertop or side
cleats.
Alternate Bracket
ScrewHoles
-"L" Bracket
Connect
Cooktop
to Gas
A malrual shut-off valve must be installed where
it will be accessible.
Assure that gas is turned off at the shut-off valve.
• Lift and remove all open top burners to reveal
tim gas inlet location at tim left rear corner.
• Pull tim flexible metal gas line through tim back
oi" bottom of tim cooktop until it meets tim
regular.
• Connect flexible metal connector to incoming
gas line pipe stub.
• Turn on gas and check for leaks:
Use a liquid leak detector at alljoints and
connections in tim system.
Flexor RigidGas
LineToRegul_
Regulator
Msta]] the
Cooktop
Backguard
A backguard is required for all installations.
• Remove the top cap of tile backguard by
backing out 2 counter sunk screws. Lift off
the top cap and set aside. Retain screws.
• Insert the backguard into the channel on the
back of the cooktop.
• Fasten with screws at the bottom, through
the cooktop and into tile backguard.
(If a griddle is present, secure with 2 screws
on the left and center of the cooktop.)
• Secure the backguard to the wall with 3
screws at the top of the backguard.
• Place the top cap in position and re-install
2 countersunk screws. (12" backguard
shown.)
TopCap _
,/_-f 2Screws_,