GE JTP56 Use And Care Manual page 31

How to Set Oven for Cleaning
Easy Steps:
1. Press AUTO SELF CLEAN.
2. Press the number pads to set the clean time.
3. Press START°
1. Follow the steps in the Before a Clean
Cycle section,
2, Press AUTO SELF CLEAN+
3. Press the number pads to set the clean
time, if a time other than 4 hours is
needed.
Clean time is normally 4 hours° You can
change the clean time to any time
between 3 to 5 hours, depending on the
amount of soil in your oven°
4. Press START,,
The door locks automatically, The display will show
the clean time remaining, It will not be possible to
open the oven door until the temperature drops below
the lock temperature and the LOCKED DOOR light
goes off.
5. When the LOCKED DOOR light is off, open
the door,
NOTE:
• You can find out when the clean cycle
will start by pressing DELAY START.
• The display will flash and the control
will beep if you set the clean cycle and
forget to close the oven door.
To Stop a Clean Cycle
1. Press CLEAR/OFE
2, When the oven has cooled below the locking
temperature and the LOCKED DOOR light
goes off, open the door.
(con6nuedn_page)
31