Coleman 9944 series Instructions For Use Manual page 5

• Place the grill o nto the
stove.
• Place griddle ateither
end ofthe stove w ith
drain s lot a tend ofstove.
• Ifusing t he stove o natable-top, allow the base o fthe propane cylin-
der t orest o nthe surface ofthe table-top. Donot u se the propane
cylinder support.
• Ifusing t he stove w ith itslegs, pull u pand rotate b ottle support
assembly until support wire isperpendicular tostove c ase.
• Proper location ofthe burner with respect tothe orifice i simportant.
To verify t he proper installation ofthe burner tube, remove the water
pan and look d ownward through the opening. The burner tube must
belocated over the brass orifice fitting.
• Check and clean t he
burner/venturi tubes for
insects and insect nests. A
clogged tube can lead t oafire
beneath the appliance.
Burner Tube
• Perform leak test outdoors.
• Extinguish all open flames.
• NEVER leak test when smoking.
• Do not use the outdoor stove until connection has been leak test-
ed and does not leak.
NOTE: Use Coleman t6.4 oz disposable propane cylinders. The LP
gas cylinder(s) used with stoves must be constructed and marked in
accordance with the specifications for LP-gas cylinders of the U.S.
Department of Transportation or Transport Canada, CAN/CSA B339,
Cylinders, Spheres and Tubesfor the Transportation of Dangerous
Goods.
Step 1
• Make sure burner valve is
off.
Step 2
• Remove plastic cap from
top of propane cylinder. Save
cap for use in storing. Screw
propane cylinder into REGU-
LATOR. Be careful not to
cross-thread. HAND TIGHTEN
only.
Step 3
• Check the connection
between the cylinder and
the regulator with soapy
water. Bubbles indicate a
leak. Check that the con-
nection is not cross-thread-
ed and that it is tight.
Perform another leak check.
If there is still a leak,
remove the cylinder and
contact Coleman for service
or repairs.
Leak
Check
• The regulator uses a
threaded fitting to attach
to the stove. It is neces-
sary to hold the stove to
make sure the fitting is
seated. Align the regula-
tor to the fuel tube on
the rear of the stove and
push on. Screw on the
outer threaded sleeve
in a clockwise direction
until tight.
Step 4
• Never operate stove with
propane cylinder in an invert-
ed position.
O