GE TFX20JAXFWW Owner's Manual page 17

Connect the Tubing to the Refrigerator
Before making the connection to the
refrigerator, be sure the refrigerator power
cord is not plugged into the wall outlet.
Oneof the illustrationsbelow wilt took like the connection
onyour refrigerato_
We recommend installing a water filter if your water Ferrule
supply has sand or particles that could clog tile
sureen of the refiigerator's water xzdve. Install it in Connection
the water line near the retiigerator.
[_Remove tile plastic flexible cap fiom the water
valve.
[_Place tile compression nut and ferrule (sleeve)
onto tile end _ifthe robing as sho_.
[_Insert the end of tile copper robing into tile
water valve connection astin aspossible. _.,\. hile
holding the tubing, tighten the fitting.
[TFasten the _opper robing into the clamp
proxfded to hold it in a vertical position.
You may need to pry open the clamp.
Tu)ngCam[ ---_ 1/4"Com[ressonN t
• _ '/_ £ _>_ \ Ferrule(sleeve)
_" _-_/ __,_-_-_ Connect,on
Nbing _7- - i
1/4" Copper Tubing Clamp
Tubing
1/4"
Compr6sion
(sleeve)
Refrigerator
Connection
Turn the Water On at the Shutoff Valve
Tighten any (onne(tions that leak.
Plug In the Refrigerator
Arrvmge tile coil of copper robing so that it does not
vibrvue against tile back of tile refiigerator or against
the wall.
Push tile refligerator back to the wall.
Start the Icemaker
Set the icemaker tbeler mm to the ON (do_lg
position. The icemaker will not begin to operate
until it reaches its operating mmperamre of 15 °F
(O oC) or below. It will then begin operation
automatically if the icemaker reeler mm is in the
ON (do_11) position.
NOTE: The icemaker may double-cycle when it
first starts, causing some water spillage from
the icemaker into the ice bucket. This is normal
and should not happen again.
17