GE TFX20JAXFWW Owner's Manual page 14

Models 20-27
Table of Contents

Advertisement

Available languages

Available languages

Preparing to install the refrigerator.
Read these instructions completely and carefully
WaterSupplyto the Icemakerco. some mo e sJ
If the refligerau)r
has an icemaker, it x_4]l h axe U)be
connected u) a cold water line.
A water supply _t (containing copper robing,
shutoffvalve, fiuings and insu_lctions) is available
at extra cost fiom your dealer or iiom Parts and
Accessories, 800-62d-2002.
Refrigerator Location
Do not install tile refligerator
where the
temperature
xdll go below 60°F (16 ° C)
becmlse it _dll not mn often enough to maintain
proper temperatures.
Install it on a floor suong
enough
u) support
it
flflly loaded.
Clearances
Allow the fi)llowing clearances tbr ease of
installation,
proper air dr(ulafion
and
plumbing and elec u:i(al / onne(dons:
Sides ,)/8
(1,) ram)
Top
l" (25ram)
If built-in, allow 7/8" (22ram)for hinge covers.
If tile refiigerator
is against a wall on either side,
allow the tbllo_dng door clearances:
20', 22', and 24' models
3/4" (19 ram)
27' models
1*/_" (38 ram)
Back
l" (25 ram)
Rollers
The rollers have 3 purposes:
[_Rollers
adjust so the door closes easilywhen
opened about halfway. [l_tise tl_e fiom about
_/ ..... 1_
b _ { ,)mm)fiomthefloor.]
To assure that the doors _dll close automatically
fiom a hahqvW open position, dmre is a buih_in tilt
ii'om the tiont to the back of the cabinet. Side-b F
side refiigerators
also have specially designed door
binges that lift both doors slightly when opened,
alh)_dng the fi)r/e of graxity to help close them
sec:urely.
[_ffRollers adjust so tl_e refiigeramr
is firmly
positioned on (lie floor and does not wobble.
_[Rollers
allow you u) move tile refiigeraU)r away
fi'om tile wall'for cleaning.
To adjust the rollers, remove
(lie base grille by pulling
it out at the bottolTa.
Turn tl_e roller adjusdng screws clockwise to raise
the refrigerator,
counterclockwise to Iowerit. Use an
(./8
hex head boh) or pliers.
adjustablewren(h
3
"
Toreplace base grille, align prongs on back of grille
with (l_u_l_Sin (abinet and push fi)rward until grille
snaps imo place.
/4

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents