GE AGE14 Owner's Manual And Installation Instructions page 11

Prepare the Window
] Loosely attach the sill brackets to the
support brackets using the 2 carriage bolts
and 2 lock nuts.
Supportbracket
Lock nut
] Open the window and mark the centerline
of the window stool. Measure and mark 11"
to the left and right of the centerline.
Install the Case in the Window
]Align the inside edge of the sill brackets
with the 11" marks from the centerline
and attach them to the window sill using
2 vype B screws on each side.
[] Careffdly place tile case on the window
stool aligning the center front on the
bottom with the centerline marked on the
window stool. Close the window making
sure the window sash is behind tile top
mounting rail.
] Using the larger diameter hole in the case,
attach the brackets to the case using two
type D screws and 2 lock nuts on each side.
] Secure tile case to the window stool by
using 3 vype B screws.
] Pull the accordion panels to each window
sash track. Attach them on each side to the
window sash and the window stool using
4 vype C screws.
]Adjust the carriage bolts and the lock nuts
in each support so that the case is installed
with a slight tilt to the outside. Use a level;
about 1/3 bubble will be the correct case
slant to the outside. Tighten the bolts.
CAUTION:DO N OT rill ahole in
thebasepan. Theunit is designedto operatewith
approximately1/2" of water in thebasepan.
11