GE JDP39 Owner's Manual page 24

Before you call for service...
Troubleshooting tips
Possible Causes
"F- anda number
or letter"flash
in thedisplay
What To Do
You have a function
error code.
If the function code repeats.
• Press the CLEAR/OFFpad. Put the o_en back into
operation.
• Disconnect all power to the range tot at least 30
seconds and then reconnect power. If the flmction
error code repeats, call for service.
• On sell=cleaning models, if a flulction error code
appears during the sell=cleaning cycle, check the oven
door latch. The latch may have been moved, if only
slightl> fl'om the locked position. Make sure the latch
is moved to the right as tar as it will go. Press the
CLEAR/OFFpad. Mh)w the o'_en to cool tot one houx:
Put the oven back into operation.
Display flashes "bAd" The installed cmmection • (:ontact installer or electrician to correct miswire.
then "linE" with a from the house to the unit
loud tone is miswired.
Displaygoesblank
A fuse in your home may be
• Replace
the fi/se or reset the circuit breaker;
blown or the drcuit
breaker tripped.
The clock is turned off from • See the
Using the clock and timer
section.
showing in the display,
Display flashes
Power failure. • Reset the ch)ck.
Unable to get the
Oven control pads were • The BAKE and
BROIL HI/LOpads
must be l)ressed
display to show "SF"
not pressed properly, at the same time and held fol 3 seconds.
Power outage,
Power outage or surge. • Reset the clock./f the oven was in use, you must reset
it by, l)ressin_r' _ the CLEAR/OEEpad, ,settiu_*_ the
clock
clock flashes and resetting any cooking flmction.
"Burning" or "oily"
This is normal in a new • To speed the process, set a sell=clean cycle for a
odor
emitting
from oven and will disappear minimum ot 3 hours. See the
Using tho
self-
the vent in time. cleaning oven section.
Strong odor
An odor from the insulation • This is
tellll)Ol'al'y.
around the inside of the
oven is normal for the first
few times the oven is used,
24