GE ZGU36L4DD1SS Owner's Manual page 18

Care and Cleaning
Stainless Steel Cooktop
The burner assemblies should be washed
regularly and, of course, after spillovers.
Turn all the controls to OFF before remoxdng
the burner parts.
The electrode of the spark ignitor is exposed
beyond tile top of the burnen When cleaning
the burner tray, be careful not to snag the
electrode of the spark ignitor with your
cleaning cloth. Do not hit the spark ignitol:
Be careful not to turn on any surface controls
while cleaning the burner tray. A slight
electrical shock might result which could
cause you to knock over hot cookware.
The burner grates and burner caps can be
lifted of[, making them easy to clean. Removing
them gives you access to tile burner bases.
To avoid snagging cloth on the spark ignitors,
leave burner caps in place when cleaning rile
burner tray.
The burners have been designed in two pieces
for ease of cleaning. When the burner grate
and the burner are cool, remove the grate.
The burner caps can easily be lifted off.
Wash these parts in hot soapy warm; rinse
and dry thoroughly.
A bristle brush can be used to clean out the
burner ports, if necessa W.
The burner grates are porcelain enamel. When
cool, they may be wiped clean using hot, soapy
warm; then rinsed and wiped &T- When lifting
the burner grates, be careful as they are heavy.
Place them on a protected surface so riley won't
scratch the surface of tile cooktop.
ignitor
Simmer
cap
Outercap/
burnerpo_s
Burner
base Locatingpin
CAUtiON:
Donotoperate theburner withoutall burnerpartsin place.
Mter cleaning, it is important to make sure the
indentation on the bottom side of the outer
cap/burner port is properly aligned with the
corresponding locating pin in the burner base.
Incorrect alignment will produce poor burner
performance.
18