Akai PDP4249G Manual page 27

Important Information:
Before proceeding to color adjustment, please read the following notes carefully.
This guick guide is for user who has his/her own preference in color adjustment setting.
1. Each and every set of PDP has been carefully tested and tuned to its optimal
color displayed level before leaving the factory.
2. The value for these optimal color displayed levels are stored in the set. They can be
restored by selecting "Load Factory" under the function of "Utility" in the OSD
Menu.
3. Picture's displaying color quality will vary under different video signal input. This is
due to different resolution capability each video signal input carries.
STEP1
Briqhtness / Contrast:
When the picture is too bright or with too much reflections on the objects' surface, it may
cause the picture to have whitish and unclear image. When this happens, try adjusting
Brightness/Contrast Value. It is recommended to tune the value of Contrast Ratioa
little higher than the Brightness(with value of 10 higher). For example, if the
Brightness is with value of 50, then the contrast Ratio should be with value of 60. This
method will make the picture with sharper and more clear image.
STEP 2
Sharpness:
The higher of thesharpenss, the more clear the image will show. Please note that if
the video signal input is with lower resolution, tuning the sharpness too high may cause
the objects in the picture with uneven edge. It is recommended to set the Sharpness
level in the middle and adjust it according to the resolution capability of the video
signal input.
STEP 3
Color:
For picture with fuller color, please tune the color level higher. The image will become
Black and White when the value of Color is too low. Recommended to set the Color
level in the middle and adjust it according to your preference.
PAGE 27