Switching Modules On And Off With Your Foot During Play (Manual Mode) - Zoom G7.1ut Operation Manual

Switching Modules On and Off With Your Foot During Play
The condition where foot switches 1 – 4 are used to switch the major modules in a patch on and off
individually is called "manual mode". In this mode, the single effects of the G7.1ut can be controlled with
your foot like independent compact effects.
1.
In play mode, select a patch.
2.
Press and hold the BANK [W] foot
switch for at least 1 second.
Hold down for 1 second
or more
The LED of the BANK [W] foot switch lights up
and the G7.1ut switches to manual mode.
Patch level
Shows the output
level of the currently
Shows the number of the
selected patch.
parameter knob that controls
the patch level.
NewDrive ™LVL100 NewDrive LVL100
ÉBpmTp BpmTp é
Function foot switch "E" symbol
assignment
If the currently displayed
Shows the function setting value differs from
assigned to the function
the original patch setting,
foot switch (→ p. 34).
the indication "E" (for
"Edited") appears.
BANK [W] foot switch LED
This is always lit when the G7.1ut is in manual mode. When you press this
foot switch in manual mode, the unit returns to play mode.
Foot switch 1 - 4 LEDs
When the module for the respective foot switch is on, the respective LED is lit.
18
(Manual Mode)
In manual mode, the following information
appears on the panel (see illustration below).
NOTE
In manual mode, you cannot use the foot switches
to select patches. However, the [TYPE] knob
(group/bank selection) and the parameter knob 1
(patch selection) operate in the same way as in
play mode. Please note that you go back to "play
mode" when you change patches.
3.
To switch a module between on and
off, press the foot switch for that
[PRE-AMP A/B] keys
The key for the channel (A or B) that is
currently selected for the pre-amp section is lit.
Effect module keys
Keys for modules that are active in the
currently selected patch are lit in red.
ZOOM G7.1ut

Switching Modules On and Off With Your Foot During Play (Manual Mode)

module.
In manual mode, you can use foot switches 1 – 4
to switch the major effect modules on or off. The
module/switch allocation is as follows.
Foot switch 1 Foot switch 3
WAH/EFX1 MOD/EFX2
module module
Foot switch 2 Foot switch 4
PRE-AMP DELAY
module module
HINT
• When a module is switched on/off, the [STORE/
SWAP] key lights up.
• In manual mode, you can use the knobs on the
panel as in play mode to adjust pre-amp
parameters, patch level, and the tube energizer.
For an explanation of operation procedures, see
"Adjusting the sound" in the section on play
mode ( → p. 15).
• From manual mode you can switch to edit mode
for editing patches. For details on edit mode,
see page 23.
4.
To return to play mode, press the
BANK [W] foot switch.
ZOOM G7.1ut
NOTE
The changes that you have made to a patch will be
lost when you select another patch. To keep the
changes, store the patch first ( → p. 27).
19