Overwriting Libraries During The Auto Store Operation - Yamaha PM1D Supplementary Manual

3 SCENE MEMORY
These are the number and title of the scene to be recalled.
Click the button to display the TC EVENT pop-up
window, then click the number of a scene to select it.
Button
Recalls the specified scene. Specify a
DIRECT scene to recall in the section to the
right.
Recalls the subsequent scene (regis-
INC
tered just after the current scene).
Recalls the previous scene (registered
DEC
just before the current scene).
DISABLE Recalls no scene.
4 EVENT RECALL
These functions enable you to recall events. The following
three buttons are provided.
Button
When you click this button, the event pre-
PREV ceding the last-recalled event in the list
will be recalled and selected.
When you click this button, the event cur-
DIRECT rently selected in the event list will be
recalled.
When you click this button, the event fol-
lowing the last-recalled event in the list
will be recalled and selected. This button
NEXT
is useful when you recall an event that
has been assigned as "[MANUAL]" in the
EVENT TRIGGER column.
5 MOVE UP/MOVE DOWN
These buttons move the currently-selected event one posi-
tion earlier (MOVE UP) or later (MOVE DOWN) in the
event list.
Note
• If the EVENT TRIGGER column of the selected event shows a
time code, these buttons will be grayed-out and unavailable. To
change the order of each event that displays a time code,
change the time code.
6
Changes in Scene Memories and Libraries
Function
Function
Overwriting libraries during the Auto
Store operation
When you store scenes using the Auto Store function, you can
now select an unused library or the original library as the ini-
tial store destination.
The following buttons are now available in the SCENE STORE
pop-up window that is displayed when you press the SCENE
MEMORY [STORE] switch (or the STORE button in the
MEMORY screen).
DEFAULT EDIT LIBRARY NO.
The lowest unused library numbers will be
NEW selected. (This is the same as the previ-
ous software version.)
The number of the most-recently recalled
library will be selected. (If the scene was
specified as read-only, or if the corre-
sponding library is write-protected, the
lowest-numbered unused library will be
OVERWRITE
selected.) This selection is useful when
you wish to prevent a particular library
from becoming full or lacking space dur-
ing the Auto Store operation, or when you
wish to edit a particular library.
Note
• This setting is remembered when you close the pop-up
window.
DEFAULT EDIT LIBRARY NO.