Switching To 3D And 2D Mode; Usage Range Of The 3D Glasses; Recharging The 3D Glasses Battery; Using The 3D Glasses With An External Power Supply - Sharp AN-3DG20 Operation Manual

Using the 3D Glasses

Switching to 3D and 2D Mode

When viewing 3D images, you can slide the switch
between 2D and 3D modes. This is useful when several
people are viewing 3D images on the same TV with
some people wanting to watch in 3D and some people
wanting to watch in 2D.
■
Viewing 2D images
When you slide the switch to 2D while viewing 3D
images, the 3D images switch to 2D images.
■
Viewing 3D images
When you slide the switch to 3D while viewing 2D
images, the 2D images switch to 3D images.

Usage Range of the 3D Glasses

The 3D Glasses can be used by receiving an infrared
signal sent from the TV.
The 3D Glasses turn off automatically after 10 minutes if
no signal is received from the TV.
■
Operating range
From directly in front of the 3D infrared emitter on
the TV: approx. 5 m (within approx. 30° horizontally
and 20° vertically)

Recharging the 3D glasses battery

When the battery power is low, the LED light blinks one
time per second. If the 3D glasses battery runs out, you
can recharge the 3D glasses battery by connecting the
supplied USB cable to the TV and the power-supply
terminal on the 3D glasses.
1
Turn off the TV, and then slide the switch on the
3D glasses to OFF.
2
Connect the cable shown below before turning
on the TV.
• The LED light blinks once per two seconds, and
then starts recharging.
• When the LED light goes off, the recharge is
complete. It takes 90 minutes to complete the
recharge.
• Insert the USB cable again if the LED light blinks
on and off once every 0.5 seconds. If it still
doesn't respond, inquire with a retail dealer or
SHARP customer service.
3
After the recharge has completed, turn off the
TV, and then remove the USB cable from the 3D
glasses.
1 USB cable (supplied accessory)
2 Power-supply terminal
CAUTION
• Do not recharge while wearing the 3D glasses.
NOTE
• Be sure to turn on the TV when you recharge the 3D
glasses battery. If the TV is turned off, you may not
recharge it.
• When you recharge the 3D glasses battery, only
connect the USB cable (supplied accessory) to a USB
terminal on the TV.
• The battery will not recharge during usage with the
USB cable connected.
• Recharge the battery within the operating temperature
(10°C–40°C/50°F–104°F). The battery may not be able
to recharge outside of the operating temperature.
Using the 3D glasses with an
external power supply
You can use the 3D glasses with an external power
supply when you slide the switch on the 3D glasses to
3D or 2D after steps 1 and 2 in Recharging the 3D
glasses battery (recharging will not complete).
NOTE
• Do not move around while wearing the 3D glasses.
You may result in getting your feet caught in USB
cable, the TV falling or other accidents that may cause
injury.
• When you supply power to the 3D glasses, only
connect the USB cable (supplied accessory) to a USB
terminal on the TV.
• When you use the USB cable connecting the 3D
glasses, careful not to get your feet caught in the USB
cable. It may result in falling or other accidents that
may cause injury.
EN-5