System preparation
Make sure to unplug the AC power lead
before installing the unit or changing the
position.
Select from three installation methods according
to the preferred position.
Using spikes
Nuts (secured on spikes) must be used when
installing spikes.
The unit can be levelled by adjusting the spikes
and nuts.
Tighten all spikes as shown
Notes:
Option 1 or option 2 indicates spike positions
●
based on LCD TV stand.
When attaching the spikes, place the unit on
●
a cushion or soft cloth to avoid damage.
Caution:
When using these spikes on glossy or slippery
table such as on glass top, stick foot cushions at
the bottom of the spikes to avoid slippage.
Using foot cushions
Attach foot cushions as shown
Option 1
Option 2
Option 1
Option 2
Note:
Option 1 or option 2 foot cushion positions based
on LCD TV stand.
To mount the unit on the wall
Caution:
Be very careful to prevent the unit [1.90 kg
●
(4.19 lbs.)] from falling when mounting on the
wall.
Before mounting, check the wall strength. (Do
●
not put on the veneer plaster or whitewashed
wall. The unit may fall.) If unsure, consult a
qualified service technician.
Mounting screws are not supplied. Use
●
appropriate ones.
Check all wall mount angle screws for
●
looseness.
Select a good location. If not, accidents may
●
occur or the unit may get damaged.
SHARP is not responsible for accidents
●
resulting from improper installation.
Driving screws
■
SHARP designed the units so you may hang them
on the wall. Use proper screws (not supplied). See
below for size and type.
5 mm
(3/16")
Min. 22 mm (7/8")
Wall mount angle fixed
■
to the wall (Horizontal
position)
Fix the pattern paper to the wall in horizontal
position as below.
Wall surface
29 mm
E-5
3.2 mm (1/8")
9 mm (3/8")
44 mm
509 mm
44 mm
Pattern paper
29 mm