Sharp HT-SB250 (BK Operation Manual page 12

General control (continued)
Remote control operation:
Press the VOLUME + button to increase the volume
and the VOLUME – button to decrease the volume.
Muting
■
The volume is muted temporarily
when pressing the MUTE button
on the remote control. Press again
to restore the volume.
Preset sound mode
■
Main unit operation:
To change to a different mode, press the
SURROUND button repeatedly until the desired
sound mode lights up.
Remote control operation:
Press a desired sound mode on the remote
control.
WOW HD is on for nominal
WOW HD is on for nominal effect.
STANDARD
standard
effect
WOW HD on for cinema/game sound effect
CINEMA/GAME
WOW HD on for cinema/
WOW HD on for sport broadcasting
CINEMA/gAME
SPORT
game sound effect
WOW HD on for news
NEWS
WOW HD on for sport
SPORT
broadcasting
neWs
WOW HD on for news
Subwoofer level control
■
The unit level can be adjusted.
To increase the level, press
the SUBWOOFER LEVEL
button.
To decrease the level, press
the SUBWOOFER LEVEL
Note:
When sound from the unit is distorted, decrease
the subwoofer level.
-5 -4 ... 4 5
button.
E-0
Bass control
■

Press the
BASS/TREBLE
button to select
"BASS".
2
Within 5 seconds, press the VOLUME
(+ or –) button to adjust the bass.
Treble control
■

Press the
BASS/TREBLE
button to select
"TREBLE".
2
Within 5 seconds, press the VOLUME
(+ or –) button to adjust the treble.
Function
■
When the FUNCTION
button on unit or LINE
button on the remote
control is pressed, the
input source will change.
Press the FUNCTION
button on unit or LINE button on the remote control
repeatedly to select desired input source.
Note:
The backup function will protect the memorised
function mode for a few hours should there be
a power failure or the AC power lead becomes
disconnected.
Auto power on function:
When you press the LINE button on the remote
control, the unit will turn on at last function.
Auto power off and auto detect signal:
If no signal is detected for 20 minutes during
●
power on, the unit will automatically go to
stand-by mode. The STAND-BY indicator
turns red.
The unit will automatically power ON if
●
it detects audio signal from connected
equipment, unless it is turned off manually.
-5 +5
-5 +5
LINE 1
LINE 2