Table of Contents
Advertisement
Playing Back
Before You Begin
PLAYING BACK
Playing Back
Use
and then press
1
Press the
button in the recording pause
status.
The DVD video camera/recorder will enter
the playback mode, and the scene you have
recorded last will be played back. (For
"scene", see p. 96 and "Terminology", p. 135.)
When playback is finished, the DVD video
camera/recorder will enter the pause status
at the last image on disc.
If the playback pause status continues for as
long as 5 minutes, the DVD video camera/
recorder will automatically return to the
recording pause status.
2
Press the
button.
Playback will stop, and recording pause
status will be restored.
• Insert a disc or card recorded on this DVD video camera/recorder (p. 46,
48).
• Turn the DVD video camera/recorder on (p. 41).
STOP/EXIT
/
/
/
to select,
to designate.
:
Note
• If the LCD monitor is open during playback of movie,
playback sound will be heard from the speaker. Adjust
the sound volume using the volume control buttons
( ,
).
• To temporarily stop playback, press the
Press the
button again to restart playback.
• Even if you stop playback midway and immediately
start recording again, the new image will be recorded
after the last scene on disc or card (the previous
images will not be overwritten).
• Image data edited on PC, etc., or the recorded image
may not appear on this DVD video camera/recorder;
also, the recorded sound may not play back,
depending on the type of image data.
• Image data recorded on another DVD video camera/
recorder or DVD recorder may not be played on this
DVD video camera/recorder.
• Depending on the amount of data to be played back,
it may take some time for the playback image to
appear.
• Do not operate the power switch or remove the card
while the ACCESS or CARD ACCESS indicator is lit
or blinking: Doing so may damage the card or the
data on card.
button.
55
Advertisement
Table of Contents
