Table of Contents
Advertisement
Turning DVD Video Camera/Recorder On and
Off
While holding down the grey button at the right
of power switch, set the switch according to
each recording function:
Set to "OFF":
The DVD video camera/
recorder will turn off
Set to " ":
To record still on SD
memory card
Set to " ":
To record movie on DVD-
RAM/DVD-RW/DVD-R/
+RW disc
Set to " ":
To record still on DVD-
RAM disc
Power ON status
During playback, set the power switch to " "
or " " when using disc, or set it to " " when
using card.
Turn the switch while holding down the grey
button at the right of switch.
Power switch
32
:
Note
• Once you turn the DVD video camera/recorder on to
let it recognise the disc, you can immediately record
or play back by turning the DVD video camera/
recorder on again. However, if a long time has
elapsed after the disc was inserted, it will take some
time for the DVD video camera/recorder to start
because it must recognise the disc again (see
"Troubleshooting" on page 137).
• It will take some time for the DVD video camera/
recorder to display the Disc Navigation screen after
power is turned on.
• When the DVD video camera/recorder is turned on,
the self-diagnosis function will work and a message
may appear. In this case, refer to "Trouble Messages"
on page 131 and take corrective action.
Advertisement
Table of Contents
