Hitachi AXM75DAB Instruction Manual page 14

RDS (RADIO DATA SYSTEM) for
FM only
RDS (Radio Data System) allows for the
name, specific type of program and text
of the radio station being played to be
displayed and for the time of the clock
to be adjusted automatically if this
information has been transmitted. "RDS"
is displayed on Multi-function display 1
when the received station has the
information transmitted.
To display various R.D.S. information on
multi-function display 1 after tuning to a
FM station, press the R.D.S. select button
6, the name of the station is displayed on
the multi-function display 1. SLIGHTLY
rotate the multi-function jog 8 clockwise,
other RDS information is displayed on the
multi-function display 1 consecutively as
follows:-
- specific type of program broadcasted
e.g. VARIETY, POP, MUSIC etc.
- time of the clock transmitted by the
radio ststion.
- text transmitted by the radio station.
Select the tuner preset station
memories
On the tuner:
Select the preset station memories 1-32
using the pushbutton 3. To select a two
digit preset station memory, press the
relevant numeric pushbuttons in succession.
The display 1 serves for check purposes.
Using the remote control
Select programme place 1-32 by pressing
numeral buttons 57.
Programme memory
The program memory allows you to save
32 stations in FM and 16 stations in AM(MW)
AMPLIFIER AND TUNER
14
band. You can directly call up the saved
stations using the preset station memory
pushbuttons on the tuner or on the remote
control.
The saved stations remain saved even if
the tuner is switched off or if there is a
power failure.
In order to store your stations to the
desired programme places proceed as
follows:
1. Make sure that your radio is in operation
mode TUNER, if necessary, switch over
with button "DAB/FM/AM" 2.
2. Adjust the desired station as described
under "Station Tuning". Here you have
the possibility of selecting manual
tuning or auto tuning.
3. Press button "MENU/STORE" 5. The
programme place number is flashing
in multi-function display 1.
4. Now select the desired programme
place number within the following 5
seconds by using numeral buttons 3.
5. Then press button "MENU/STORE" 5
to save the programme.
Attention:
In case the input does not take place within
these 5 seconds, the programme place
number remains the same. The storage
function can only be activated again by
pressing button "MENU/STORE" 5
afterwards.
Changing a programme number
If you wish to store a different station under
any programme number, you can do so
following the procedure described above.
The old station will be cleared.