Quick Record Setting - Pelikan 9CH MPEG4 User Manual

QUALITY
RECORDING
SENSOR
RECORDING
PRE RECORD
POST EVENT
RECORD
AUDIO
SCHEDULE

3-3-1. Quick record setting

User can setup all the values related with record such as Frame rate, quality, recording type,
Pre-recording, and Post-recording on one page of setup screen.
1. Go to Record>Channel and press SEL button.
2. Then the bellow setup screen will pop up.
60/50 fps: 704*480(NTSC)/704*576(PAL)
480/400fps version:
480/400fps: 352*240(NTSC)/352*288(PAL)
240/200fps: 704*240(NTSC)/704*288(PAL)
120/100 fps: 704*480(NTSC)/704*576(PAL)
Select the recording quality for the specified channel. Options are:
Network, Standard, High, Super or Ultra.
Assign the recording mode for each channel. Options are:
Continuous, By Motion, By Sensor, By Schedule or Disable.
Enable setting up to 4 sensors of 9 sensors for the specified
channel.
Enable/disable pre-event recording. Pre-event recording time is 5
seconds and only intra-frames are recorded for pre-event
recording.
Set the post event recording time duration for the specified channel
from 1 to 30 seconds.
Enable/disable audio recording for the specified channel.(Available
from 1CH to 4 CH-Fixed)
Set the recording schedule. This menu item takes you to the
Schedule Setup screen.
23