Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Outlaw ECS-10
Summary of Contents for Outlaw ECS-10
- Page 1 Enhanced Cube Subwoofer ECS-10 Owner’s Manual Version 1.0...
-
Page 2: Please Read First
AC power source. Many modern electronics products feature automatic The high power output of your Outlaw ECS may require heavy power draw under full load turn-on circuits that may be activated during an installation, causing the potential for conditions. -
Page 3: Table Of Contents
Always refer to the instructions that came with the receiver or processor for ■ specific procedures, warnings and options. The contents of this manual are Copyright © 2009 by Outlaw Audio, LLC, and may not be Make sure to insert all plugs and connectors securely. Improper connections ■... -
Page 4: Subwoofers, Bass And Overall System Performance
A properly By limiting their frequency range, these speakers may be made smaller, to more designed subwoofer such as the Outlaw ECS-10 can provide a visceral impact easily fit into a wide range of spaces. However, by eliminating the capability to that most speakers are not able to provide on their own. -
Page 5: Ecs-10'S Controls And Connections
(in the case of systems without a left/right pre-amp outpt) or additional This knob controls the output level of the ECS-10. speaker wire. We recommend the Outlaw Audio PCA SUB cable, but any high C AUTO ON/OFF Power Switch quality, shielded audio interconnect will work properly. -
Page 6: Connecting To A System Without A Subwoofer Preamp Output, But With Standard Left/Right Preamp Outputs
4. Locate the connections labeled “INPUT” on the rear panel of the ECS-10 preamp outputs, you can use these jacks to connect your receiver or processor to the and connect the other end of the interconnects to these jacks. subwoofer amplifier. See Diagram 2 below. Outlaw Audio... -
Page 7: Connecting To A System With No Preamp Outputs
Owner’s Manual Subwoofer Placement 5. If you are using a separate power amplifier, connect a second set of 1. Turn off all system components and unplug the receiver and/or amplifier interconnects to the connections labeled “OUTPUT” on the ECS-10 and the ECS-10 from their AC power source. power amp. -
Page 8: Subwoofer Placement
“slow” setting. Note: The Radio Shack meter is down about 12 dB at 16 Hz, 7 dB at 20 Hz, and 4 dB at 25 Hz. Add these numbers to the readout to compensate for these errors if necessary. Outlaw Audio... -
Page 9: The Scattered Subwoofer System (Two Ecs-10'S)
Y-adapter that is of equal or better quality than the subwoofer cables you may be occasional problems upon initial installation, or during the life of the unit. intend to use. (We recommend the Outlaw Audio PCA Y-Adapter.) Troubleshooting Guide To use the Y-adapter, insert the single male end of the cable to the subwoofer output of your receiver or processor. -
Page 10: Outlaw Service Information
866-688-5292. It is important that only a service agent authorized by Outlaw Audio carry out any repairs. Keep your sales slip or receipt in a safe place with this manual so that it... -
Page 11: Outlaw Audio Limited Warranty
This warranty protects the owner of the Outlaw Audio LLC (hereby referred In the event that you wish to return your Outlaw ECS back to us, for any reason, please call to arrange for a Return Authorization Number. This will to as Outlaw Audio) ECS-10 Enhanced Cube Subwoofer (the PRODUCT) for three (3) years from the date of purchase.
Need help?
Do you have a question about the ECS-10 and is the answer not in the manual?
Questions and answers