Euro-Pro SHARK TRAILBLAZER EP825 User Manual

Upright Vacuum
Item # XSG825
for Model EP825
10 Paper Bags – 2 Belts – 1 Bulb
Warning:
To reduce the risk of electric shock, the power cord
must be disconnected before changing the bag or
performing maintenance/trouble shooting checks.

Changing the Dust Bag:

A) Unplug power cord from wall outlet.
B) Remove the front panel of the unit.
C) Remove the old dust bag by holding the cardboard tab and pull
towards you. Remove carefully to avoid dust/dirt spilling from dust
bag.
D) Take a new dust bag and while holding the cardboard tab push the bag
over the opening of the dirt discharge tube until it is seated against the
rear of the enclosure.
E) Make sure that the entire bag is inside the housing, before replacing
the front panel. Always check the pre-motor and post motor filters
every time you change the dust bag.
F) Once the new dust bag is in place, replace the front panel by aligning
the bottom locking tabs with the slots in the body, close cover slowly
allowing the front panel to snap in place. The latch will self lock.
NEVER REUSE PAPER BAGS
For information or assistance, call 1-866-98SHARK (1-866-987-4275)
USA: EURO-PRO Operating LLC
21 Lawrence Paquette Industrial Drive
Champlain, NY 12919
or visit our website: www.sharkvac.com
Canada: EURO-PRO Operating LLC
4400 Bois Franc
St. Laurent, QC H4S 1A7
Rev.12/03
Printed in China
Upright Vacuum
Item # XSG825
for Model EP825
10 Paper Bags – 2 Belts – 1 Bulb

Warning:

To reduce the risk of electric shock, the power cord
must be disconnected before changing the bag or
performing maintenance/trouble shooting checks.
Changing the Dust Bag:
A) Unplug power cord from wall outlet.
B) Remove the front panel of the unit.
C) Remove the old dust bag by holding the cardboard tab and pull
towards you. Remove carefully to avoid dust/dirt spilling from dust
bag.
D) Take a new dust bag and while holding the cardboard tab push the bag
over the opening of the dirt discharge tube until it is seated against the
rear of the enclosure.
E) Make sure that the entire bag is inside the housing, before replacing
the front panel. Always check the pre-motor and post motor filters
every time you change the dust bag.
F) Once the new dust bag is in place, replace the front panel by aligning
the bottom locking tabs with the slots in the body, close cover slowly
allowing the front panel to snap in place. The latch will self lock.
NEVER REUSE PAPER BAGS
For information or assistance, call 1-866-98SHARK (1-866-987-4275)
USA: EURO-PRO Operating LLC
21 Lawrence Paquette Industrial Drive
Champlain, NY 12919
or visit our website: www.sharkvac.com
Canada: EURO-PRO Operating LLC
4400 Bois Franc
St. Laurent, QC H4S 1A7
Rev.12/03
Printed in China