Sharp BD-HP20X Operation Manual page 42

SETTINGS
5
Press a/b/c/d to select the speaker, then
press ENTER.
MENU [SPEAKER SETTINGS]
0dB
SW
3.8m/0dB
L
LS
2.0m/0dB
TEST START
6
Press c/d to select the preferred item, then
press a/b to select the preferred setting, then
press ENTER.
MENU [SPEAKER SETTINGS]
0dB
SW
3.8m/0dB
L
LS
2.0m/0dB
SIZE
LARGE
Speakers
L/R LARGE*, SMALL
C/RS/LS LARGE*, SMALL, NONE
SW YES*, NO
* Factory preset
LARGE: The cone diameter is 16 cm or larger.
SMALL: The cone diameter is smaller than 16 cm.
Selectable Distance 0.1m through 9.0m
range (Settings available in 0.1m increments)
The factory preset value: 3.8m(L/R/C)
2.0m(RS/LS)
Selectable Output -6dB through +6dB
Level range (Settings available in 1dB increments)
The factory preset value is 0dB.
40
3.8m/0dB
C
3.8m/0dB
R
RS
2.0m/0dB
FINISH
3.8m/0dB
C
3.8m/0dB
R
RS
2.0m/0dB
DISTANCE LEVEL
3.8 m 0dB
Selectable size
7
Repeat steps 5 and 6 until each speaker's size,
distance, and level are set.
MENU [SPEAKER SETTINGS]
0dB
SW
3.8m/0dB
L
LS
2.0m/0dB
TEST START
NOTE
• The speakers L and R, LS and RS move relative to one another.
• The speakers L and R are automatically set to "LARGE" when the
subwoofer SW is set to "NO", even after speakers L and/or R are
set to "SMALL".
• The images of speakers set to "NONE" disappear or are greyed
out on the screen.
• As for a subwoofer, there are no settings for distance.
Checking the setup sound
8
Press a/b/c/d to select "TEST START", then
press ENTER.
MENU [SPEAKER SETTINGS]
0dB
SW
3.8m/0dB
L
LS
2.0m/0dB
TEST START
• After switching to TEST mode, you can hear the Test
sound from each speaker in turn.
• If you press a/b/c/d to select the preferred
speaker while the TEST sound is present, you
can hear the TEST sound of the speaker that you
selected.
• If you press a/b/c/d to select "TEST TONE
STOP" and press ENTER, you can stop the Test
sound
3.8m/0dB
C
3.8m/0dB
R
RS
2.0m/0dB
FINISH
3.8m/0dB
C
3.8m/0dB
R
RS
2.0m/0dB
FINISH