Advertisement
INSTALLING
THE ATTACHMENT
PIN
STEP 25: (REFER BACKTO FIGURE 22 ON PAGE 14)
*
Lift the front of the snow blower to align the holes in
the mounting plates and the side plates. From the left
side of the tractor insert the attachment pin through
the holes. Secure it with by reinstalling the 1/8" hairpin
cotter.
ATTACH
REFLECTORS
TO REAR FENDER
STEP 27: (SEE FIGURE 26)
*
if your tractor is not equipped with rear reflectors,
assemble the supplied rear reflectors to the rear
fender. Place the reflectors as close to the bottom of
the fender and as far apart as the shape of the fender
will allow.
SETTING
THE AUGER
BELT TENSION
STEP 26: (SEE FIGURE 25)
*
Pull the tensioning chain until the end of the spring is
pulled through the hole in the side of the Clutch/Idler
assembly, install a 1/8" hairpin cotter through the end
of the spring, securing it on the outside of the Clutch/
idler assembly.
iMPORTANT:
For correct belt tension, the 1/8" hairpin
cotter must attach to the end of the spring,
not to the
chain.
NOTE; To prevent the chain from dragging on the
ground, loop the end of the chain though the pivot lock
pin.
CLUTCH/IDLER
ASSEMBLY
LEFT SiDE
:
:
o F
TRACTOR
1/8"
HAiRPiN
COTTER
FLAT
PULLEY
END OF
SPRING
FIGURE 25
VIEWED FROM UNDERNEATH
FIGURE
26
REAR REFLECTORS
CHECKLIST
Before you operate your snow thrower, please review
the following
checklist
to help ensure that you will
obtain the best performance from your snow thrower.
•
Make sure all assembly instructions have been
completed with all bolts and nuts properly tightened.
Make sure the correct drive belt was installed.
Make sure the drive belt and auger belt are routed
properly around pulleys and inside all belt keepers.
Check discharge chute for proper rotation.
•
Check operation of tilt control for upper chute.
Verify that the lift handle will lock into and release
from the raised transport position. (Refer to the
Service and Adjustments section.)
Check skid shoe adjustment. (Refer to the Service
and Adjustments
section.)
The following
additional
items are available from
Sears to help enhance the performance of your snow
thrower. See Accessories
and Attachments
on page 2.
Tire chains which can be installed to improve traction.
Rear wheel weights which can be installed in addition
to the rear weight tray to improve traction.
Snow Cab which can be installed to help protect
against wind and blowing snow.
15
Advertisement
