How To Charge The Maintenance Free Battery; How To Install The Battery Cables - Craftsman 536.27630 Operator's Manual

Mid-engine rider 13.5 hp. electric start 30" mower / mulcher hydrostatic drive
Table of Contents

Advertisement

PREPARATION
MAINTENANCE
FREE BATTERY
3
4.
IMPORTANT:
Before
you attach
the battery cables to the
battery, check the battery date. The battery date tells if the
battery must be charged.
1.
2.
3.
4.
Raise the seat support and secure in the UP position with the
seat support rod.
Check the top and the side of the battery for the location of the
battery date (Figure 1).
If the battery
is put into service before the battery
date, the
battery cables can be attached without charging the battery.
See "How To Install The Battery Cables".
If the battery
is put into service after the battery date, the
battery
must
be charged.
See
"How
To Charge
The
Maintenance Free Battery".
HOW TO CHARGE
THE MAINTENANCE
FREE BATTERY
,_
WARNING:
When you charge the battery, do not
smoke. Keep the battery away from any sparks. The
fumes from the battery acid can cause an explosion.
1.
To disconnect the battery retainer from the battery tray, push
in on the lower end of the battery
retainer.
2.
Remove the battery from the right side of the unit.
5.
Remove the protective cap from the battery terminal.
Use a 12 volt battery charger to charge the battery. Charge at
a rate of 6 amperes for one hour. If you do not have a battery
charger, have a Sears or other qualified service center charge
the battery.
Install the battery and secure with the battery retainer.
Make
sure the positive (+) terminal
is on the right side.
HOW TO INSTALL
THE BATTERY
CABLES
,_
WARNING: To prevent sparks, fasten the red cable to
the positive (+) terminal before you connect the black
cable.
Use the fasteners shown below to install the battery
cables. The
fasteners are shown at full size.
(A)
(B)
2x82
14x79
1.
Remove the protective cap from the battery terminal.
2.
Fasten the red cable and terminal
cover to the positive (+)
terminal
with the fasteners as shown (Figure 1).
3.
Fasten the black cable to the negative (-) terminal with the
fasteners as shown.
Battery
A
Positive (+)
Terminal
A
Black Cable
B
Battery Clamp
Red Cable
Figure 1
MS-3620MA
8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents