Craftsman EZ3 917.259573 Owner's Manual page 26

SERVICE AND
TO REPLACE HEADLIGHT BULB
o
e
e
ENGINE
Raise hood.
Pull bulb holder out of the hole in the backside of the
grill.
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill,
Close hood,
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting,
• Check wiring, See electrical wiring diagram tn the
Repair Parts section of this manual.
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in fuse. The
fuse holder is located behind the dash.
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 31)
- Raise hood.
= Unsnap headlight wire connector.
° Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
- To replace, reverse above procedures.
HOOD
/
TO ADJUST THROTTLE CONTROL CABLE
(See Fig, 32)
The throttle control has been preset at the factory and
adjustment should not be necessary. Check adjustment as
described below before loosening cable, If adjustment is
necessary, proceed as follows:
° With engine not running, move throttle control lever to
fast posItion.
• Check that swivel is against side of quarter circle, tf it
is not loosen cable clamp screw and pull cable back
until swivel is against quarter circle. T ghten cable
clamp screw securely.
HEADLIGHT
_\ WIRE
",,, CONNECTOR
FIG. 32
&
SWIVEL
r r
FIG. 31
26