Craftsman EZ3 917.259573 Owner's Manual page 16

OPERATION
MOWING TIPS
Tire chains cannot be used when the mower housing is
attached to tractor.
Mower should be properly leveled for best mowing
performance. See "TO LEVEL MOWER HOUSING" in
the Service and Adjustments section of this manual.
The left hand side of mower should be used for trim-
ming.
o Drive so that clippings are discharged onto the area
that has been cut. Have the cut area to the dght of the
tractor. "['his will result in a more even distribution of
clippings and mere uniform cutting.
- When mowing large areas, start by turning to the right
so that clippings wilt discharge away from shrubs,
fences, driveways, etc. After one or two rounds, mow
in the opposite direction making left hand turns until
finished (See Fig. 11 ).
- If grass is extremely tall, it should be mowed twice to
reduce load and possible fire hazard from dried clip_
pings. Make first cut relatively high; the second to the
desired height.
, Do not mow grass when it is wet. Wet grass will plug
mower and leave undesirable clumps. Atlow grass to
dry before mowing.
, Atways operate engine at full throttle when mowing to
assure better mowing performance and proper dis-
charge of material, Regulate ground speed by select-
ing a low enough gear to give the mower cutting
performance as well as the quality of cut desired.
, When operating attachments, select a ground speed
that ,_vi!t s uit the terrain and give best performance of
the attachm;_nt being used.
(
MULCHING MOWING TIPS
IMPORTANT: FOR BEST PERFORMANCE, KEEP
MOWER HOUSING FREE OF BUILT-UP GRASS AND
TRASH. CLEAN AFTER EACH USE,
* The special mulching blade wiif recut the grass clip-
pings many times and reduce them in size so that as
they fall onto the lawn they will disperse into the grass
and not be noticed. Also, the mulched grass wilt
biodegrade quickly to provide nutrients for the lawn.
Always mulch with your highest engine (blade) speed
as this wilt provide the best recutting action of the
btades.
, Avoid cutting your lawn when it is wet. Wet grass tends
to form ck._mpsand interferes with the mulching action.
The best time to mow your law# i£ the early afternoon.
At this time the grass has dried ar,d the new_y cut area
will not be exposed to the direct sun.
For best resutts, adjustthe mowercutting height so that
the mower cuts off only the top one-third of the clrass
blades (oee Fig. 12). For extremely heavy mulching,
reduce your width of cut and mow slowly.
. Certain types of grass and grass conditions may re-
quire that an area be mulched a second time to com-
pletely hide the clippings. When doing a second cut,
mow across or perpendicular to the first cut path.
* Change your cutting pattern from week to week. Mow
north to south one week then change to east to west the
next week. This will help prevent matting and graining
of the lawn.
MAX 1/3
FIG. 12
FiG. 11
16