Camera Mode Selection - Oregon Scientific ATC-1000 Manual

HC18_manual_1_sep 9/2/05 16:50
VII) Camera Mode Selection
1. You can cycle through different shooting modes by pressing the 'Menu'
button repeatedly. The LCD will display each mode as you press
the 'Menu' button.
2. Press the 'Enter' button to confirm the selection.
3. When you want to quit the Camera Mode Selection, cycle through the icons by
pressing the 'Menu' button repeatedly until the selected icon stops flashing.
4. The different mode icons are shown in the table below.
Icon Title
Self timer
Continuous shutter
Delete the last picture/clip
Delete all photos/footage
High resolution
(640 x 480 pixels)
Medium resolution
(320 x 240 pixels)
Low resolution
(160 x 120 pixels)
SD card
Low battery
Page 8
Description
10 Second timer
Takes 3 consecutive photos.
Erases the last picture/clip taken
Erases all pictures/footage
stored in the camera
Large photo format/less
storage capability
Medium photo format
Smallest photo format/
more storage capability
Shows SD card is being inserted
Battery is low when this icon appears
11
a) Default 640 x 480 pixels resolution
To change the resolution, press the 'Menu' button until
the desired resolution icon shows on the LCD display.
Press the 'Enter' button to confirm your selection.
b) Continuous Shutter Mode
Continuous shutter mode is activated by selecting
and confirmed by pressing the 'Enter' button. Press the 'Photo shutter' button
once to start. The A T C - 1 0 0 0 will take three consecutive photos accompanied by
three 'beeps'. To cancel this mode reselect
Note:
1. It doesn't work for taking video footage.
2. This function supports photos (640x480 VGA) only.
c) Self-Timer Mode
Self-timer mode is activated by selecting
'Enter' button. Press 'Movie shutter button' or 'Photo shutter button' once to
start the countdown. The ATC-1000 will count down 10 'beeps' and then start
recording. To cancel this mode reselect
d) Delete the Last Photo/Movie Clip
To delete the last photo/movie clip you shot, press the 'Menu' button until
the 'Status LCD' displays . Press the 'Enter' button to confirm.
Repeat these two steps to individually delete your files.
Note: After file deletion the LCD display will adjust the remaining number
of files accordingly.
and press the 'Enter' button.
and confirmed by pressing the
and press the 'Enter' button.
12