Advertisement
Note: When saw is purchased, the battery pack is
attached to the saw.
_lk
WARNING:
Always remove battery pack from your
saw when you are assembling parts, making
adjustments,
assembling or removing blades,
cleaning, or when not in use. Removing battery pack
will prevent accidental starting that could cause
serious personal injury.
TO REMOVE
/ ATTACH
BATTERY
PACK
See Figure 5.
TO REMOVE:
•
Depress latch located on front of battery pack (1) to
release battery pack.
•
Pull on battery pack (2) to remove from saw.
TO ATTACH:
•
Align raised ribs on battery pack with grooves on
bottom of saw, then attach battery pack to saw as
shown in figure 5.
•
Make sure the latch on _)attery pack snaps in place
and battery pack is secured to saw before beginning
operation.
Loosen the blade clamp screw enough to permit the
saw blade to be inserted between blade clamp and
saw bar.
Note: It is never necessary to remove the blade
clamp screw from the blade clamp when installing or
removing blade.
Align the hole in the shank of the blade and blade
clamp with the pin in the saw bar, then seat both on
the pin in the saw bar.
Tighten blade clamp screw securely.
Remove blade wrench and store it in wrench holder.
Replace battery pack.
BLADE
BLADECLAMP
CLAMPSCREW
'_
PIN
HOLEIN
SAW BLADE
SAWBAR
BLADE
BLADECLAMP
DEPRESSLATCHTO
RELEASEBATTERYPACK
PULLTO
REMOVE
BLADE
CLAMPHOLE
TO
INSTALL
GROOVES
TO
REMOVE
BATTERYPACK
Fig. 5
TO INSTALL
SAW BLADE
See Figure 6.
•
Remove battery pack. See Figure 5.
_k
WARNING:
Failure to remove battery pack from
saw could result in accidental starting causing
possible serious personal injury.
•
Remove the 5 mm blade wrench provided with your
saw from wrench holder. Note: Wrench holder is
located in bottom portion of saw handle. See Figure 1.
5 mmBLADEWRENCH
BLADE
Fig. 6
Note: There may be times when the blade clamp sticks to
the saw bar and will not loosen enough to allow blades to
be installed or removed. If this happens, loosen the blade
clamp screw with the blade wrench, then tap lightly on the
end of the blade wrench with a mallet. See Figure 7.
BLADE
CLAMPSCREW
BLADECLAMP
(5 mm HEX KEY)
SAWBAR
•MALLET
Fig. 7
9
Advertisement
