Advertisement
KNOW
YOUR
RECIPROCATING
SAW
See Figure I.
Before attempting te use your reciprocating saw,
familiarize yourself with all operating features and safety
requirements.
_
WARNING:
Carefully read through this entire owner's
manual before using your new reciprocating saw. Pay
close attention to the Rules For Safe Operation,
Warnings and Cautions. If you use your reciprocating
saw properly and only for what it is intended, you will
enjoy years of safe, reliable service.
Your reciprocating
saw has been shipped completely
assembred except for the blade. Inspect it carefully to
make sure no breakage or damage has occurred during
shipping. If any parts are damaged or missing, contact
your nearest Sears Retail Store to obtain replacement
parts before attempting to operate saw. Two blades, blade
wrench (5 mm hex key) and this owner's manual are also
included.
9"
_i,
WARNING
: Do not allow familiarity with your saw to
make you careless. Remember that a careless fraction
of a second is sufficient to inflict severe injury.
BLADE
WRENCH
HOLDER
A blade wrench (5 mm hex key) is packed with your saw.
A convenient feature on your saw is the wrench holder.
This is a slot located on the bottom portion of the saw
handle. It is convenient for storing the wrench when it is
not being used.
LOCK-OFF
BUTTON
Your saw is equipped with a "lock-off" button which
reduces the possibility of accidental starting. The lock-oft
button is located on the handle above the switch trigger.
You must depress the lock-off button in order to pull the
switch trigger. The lock resets each time the trigger is
released. Note: You can depress the lock-off button from
either the left or right side.
SWITCH
To turn your saw ON, depress the lock-oft button and pull
switch trigger. Release switch trigger to turn your saw
OFF,
VARIABLE
SPEED
This tool has a variable speed switch that delivers higher
speed with increased trigger pressure. Speed is controlled
by the amount of switch trigger depression.
APPLICATIONS
(Use only for the purposes
listed below)
•
Cutting all types of wood products (lumber, plywood,
paneling, composition board, and hard wood).
•
Cutting masonite and plastic.
•
Cutting drywall.
•
Cutting metals such as sheet steel, pipe, steel rods,
aluminum, brass, and copper.
_i,
WARNING:
If any parts are missing, do not operate
your saw until the missing parts are replaced. Failure to
do so could result in possible serious personal injury.
PRODUCT
SPECIFICATIONS
RECIPROCATING SAW
Blade Stroke
Motor
No Load Speed
Switch
Shank Capacity
CHARGER
Input
Charger Voltage
Charger Rate
BATTERY PACK
315.271290
1-3/16 in.
18 Volt DC
O-25OO SPM
Variable Speed
1/2 in.
ITEM NO. 9-11040
(981399-001 )
120 Volts, 60 Hz, AC only
9.6 - 24 Volt
1 Hour
ITEM NO. 9-11034
(981404-001 )
6
Advertisement
