Checking The Programmed Functions; Erasing All Programmed Functions - Onkyo PHC-5 Instruction Manual

Checking the programmed functions

Check to see if the programmed buttons operate the corresponding device correctly. If pressing one of the programmed buttons
does not cause the SENDING/LEARNED indicator on the remote controller to light up, re-program again.
SENDING/
LEARNED
POWER DISPLAY
POWER
VIDEO CONTROL
TV/VCR
POWER
TV CONTROL
TV/VIDEO VOLUME
DISTANCE
If the programmed buttons do not enable you to operate the device correctly, review the following:
The remote controller does not work unless it is close to the device, or the device has a slow response to remote con-
troller operation.
The remote controller signal may not be programmed properly. Re-program the signal again. If the problem persists, check
to see if the battery voltage is low.
The programmed signal has been erased.
The programmed remote controller signals will be erased if the batteries have been removed for more than 30 minutes. You
need to re-program the signals.

Erasing all programmed functions

POWER DISPLAY
POWER
VIDEO CONTROL
TV/VCR
POWER
TV CONTROL
TV/VIDEO VOLUME CH
DISTANCE EXPAND
MODE
SURROUND SUB
FRONT BALANCE
INPUT SELECTOR
TV VIDEO AUX MUTING
REMOTE CONTROLLER
Press one of the programmable button to operate the
corresponding device.
LEARN
CH
If the device does not respond correctly, refer to page 15.
EXPAND
LEARN
1
Press the LEARN button.
2
Press and hold the POWER button and press the
VOLUME † button.
VOLUME
Hold down both buttons until the SENDING/LEARNED indicator turns off. All
RC-382M
programmed functions will be erased.
POWER
VIDEO CONTROL
TV/VCR
POWER
TV CONTROL
TV/VIDEO VOLUME CH
LEARN
POWER
VOLUME
Perform the next step within
fifteen seconds.
17