Tools Required For Assembly - Craftsman 486.244050 Owner's Manual

Ag cart
Table of Contents

Advertisement

15
3
CARTON
CONTENTS
1. Tailgate
2. Tailgate Reinforcement
Bracket
3. Cart Bed (2)
4. Front Panel
5. Wheel Support
6. Axle, Rear
7. Front Axle Support
8. Front Axle Channel
9. Tie Rod
10. Tongue, Rear Section
11. Tongue, Front Section
12. Hitch Bracket
13. Wheels (4)
14. R.H. Axle Spindle
15. L.H. Axle Spindle
16. Tongue Reinforcement
Angle
17. Corner Caps (2)
18. Tailgate Guides (2)
19. Pivot Bars (2)
Hardware Package (page 4 )
IMPORTANT:
Due to the weight of the cart after all four
wheels are attached, it is recommended
that someone
assist you when it is time to lower the cart onto it wheels.
TOOLS
REQUIRED
FOR ASSEMBLY
(1)
Screwdriver
(1)
Pliers
(2)
7/16" Wrenches
(2)
1/2" Wrenches
(2)
9/16" Wrenches
(2)
3/4" Wrenches
(4)
Recommended - small bricks or blocks of wood
(2" x 4") for chocking the wheels,
REMOVAL
OF PARTS
FROM
CARTON
Remove all parts and hardware packages from the
carton. Lay out all parts and hardware and identify
using the illustrations on pages 3 and 4.
Lay out all the parts and hardware as shown on
pages 2 and 3.
Position cart body halves upright on a smooth level
surface such as a garage floor or a paved driveway.
See figure 1.
Assemble halves together using nine 1/4" x 1/2" hex
bolts, 1/4" lock washers and 1/4" hex nuts as shown
in figure 1. Do not tighten
at this time.
1/4" x 1/2" HEX BOLT
1/4" HEX NUT
FIGURE 1
5

Advertisement

Table of Contents
loading

Table of Contents