Craftsman 917.28858 Operator's Manual page 11

D. Right Side Rear Mower Bracket
Hole
8 ATTACH FRONT LINK (E)
• Turn steering wheel to position wheels
straight forward.
• From front of tractor, insert rod end of
front link (E) through front hole in tractor
front suspension bracket (F).
Move to left side of mower and and insert
large retainer spdng (G) through hole in
front link (E) behind front suspension
bracket (F).
• Insert other end of link (E) into hole in
front mower bracket (H) and secure with
washer and small retainer spring (J).
NOTE: Requires deck lifting.
FrontLink / ! (T;._.
Location, i Z'_'_ _ / ..... \
9 INSTALL BELT ON ENGINE CLUTCH
PULLEY (M)
• Disengage belt tension rod (K) from
locking bracket (L).
- Install belt onto engine clutch pulley (M).
M.Engine
Clutch PulLey
IMPORTANT: Check belt for proper muting
in all mower pulley grooves and under
mandrel covers.
• Engage belt tension rod (K) on locking
bracket (L).
_IbCAUTION: Belt tension rod is spring
loaded. Have a tightgrip on rod and engage
slowly.
- Raise attachment lift lever to highest
position.
• If necessary, adjust gauge wheels
before operating mower as shown in the
Operation section of this manual.
MOWER DRIVE BELT INSTALLATION
Follow procedure described in "TO
REPLACE MOWER BLADE DRIVE BELT"
in the "Service and Adjustments" section of
thismanual.
5. Front Lift Link Assembly
F. Front Suspension Bracket
G, Large Retainer Spring
H. Front Mower Bracket
J. Small Retainer Spring
M. Engine Clutch Pulley
11