Craftsman nextec HAMMERHEAD 320.61352 Operator's Manual page 15

HAMMERING NAILS (Fig. 6)
1. Attach the battery pack to
the Auto-Hammer.
2. Secure the material to
be nailed with clamps to
keep it from turning when
hammering.
3.
Fig. 6
Insert the head of the nail into
the magnetic sleeve and up
against the hammerhead,
where it will be held in place
by magnetism. Place the tip
of the nail against
the workpiece.
4. Holding the shaft of the nail steady with your hand, push down on the tool
and press the trigger switch to drive the nail far enough into the workpiece
so that it stands on its own. Release trigger switch and remove your hand
from the nail.
CAUTION: Be especially careful when driving shorter nails such as brads that
you remove your hand as soon as the nail stands on its own in the workpiece.
5. Resume pushing down on tool and pressing trigger switch to continue
hammering until the nail is fully driven into the workpiece. Near the end of
hammering, the magnetic sleeve will retract to allow the hammerhead to
drive the nail head flush to the workpiece.
WARNING: Do not force the hammer or apply side pressure. Hold the tool
firmly; the tool will hammer the nail automatically.
61352 Manual_Revised_08 0924 Page 15