GE GBC121AX Owner's Manual And Installation Instructions page 14

Installation Instructions
REVERSING THE DOOR SWING {cont.}
%
@
TRANSFER FRESH FOOD DOORSTOP
AND HOLE INSERTS
Remove the fresh food doorstop from
the bottom right side of the door.
Remove the hole insert from the bottom right
side of the fresh food door.
Install the fresh food doorstop to the bottom
left side of the door.
Install the hole insert on the bottom left side
of the fresh food door.
[]
HANG THE FRESH FOOD DOOR
Place the fresh food door onto the center hinge
over the pin.
r_ While holding the door in place, raise the top
hinge and insert the top pin into the hole in
the door. Swing door shut.
r_ Align the freezer door with the fresh food door
so the gap between the doors is even.
r_ Tighten the top hinge screws by turning them
until snug. Then turn the screws a minimum
of 1/2 turn using both hands.
INSTALL DOOR CAP
r_ Remove the insert on the bottom of the door
cap with a thin-blade screwdriver.
4
r_ Install the insert into the right side
of the door cap.
14
INSTALL DOOR CAP {CONT.}
r_ Place the top cap onto the top of the fresh food
drawer.
FD] Using the screws removed earlier, secure
the top cap onto the fresh food door, covering
the end of the hinge.
Srrew_
Screw
INSTALL HINGE COVER AND
ELECTRONICS BOX COVER
r_ Remove the tab from the left side of the hinge
cover.
r_ Install the tab into the right side of the hinge
cover.
r_ Lift up the electronics box cover and place
the middle portion of the hinge cover over
the wire harnesses and under the edge
of the electronics box cover. NOTE: Be careful
not to pinch the wiring.
[] Using the screws removed earlier, attach
the hinge cover to the cabinet.
[] Using the screws removed earlier, attach
the electronics box cover to the cabinet.
Screws Electronics
BoxCover
Screws
Hinge
Cover