GE GBC121AX Owner's Manual And Installation Instructions page 13

Installation Instructions
r_ HANG THE FREEZER DOOR
r_ using a thin-blade screwdriver, prg the center
hinge plug from the cabinet. Be careful not to
scratch the surface.
r_ Install the center hinge plug on the right side
of the cabinet where the hinge bracket was
removed.
J
......... enter rage ug_CZZE )
- "d _li
r_ Make sure the washer(s) are in place
on the bottom hinge pin. Place the freezer door
on the bottom hinge.
r_ Close the door and tape it in place with
masking tape.
I_I INSTALL CENTER HINGE
r_ Insert the pin on the bottom of the center hinge
into the freezer door on the left side with the
back of the bracket against the cabinet. The
hinge bracket will have to be inverted for this
installation. Using screws previouslg removed,
attach the hinge to the cabinet.
r_ Remove the tape holding the door shut.
CAUTION: When a ssembled
correctlg,
the hinge is tight against the cabinet.
ATTENTION: Screws must be properlg tightened.
Turn the screws until snug. Then tighten the screws
a minimum of 1/2 turn using both hands.
Screws
[] TRANSFER FRESH FOOD DOOR
HANDLE
[] Using a thin-blade screwdriver, carefullg
remove the square button plugs from the
handle. NOTE: Be careful not to scratch
the stainless steel or plastic surfaces.
r_ Remove the round button plugs on the other
side of the door. NOTE: Be careful not to scratch
the stainless steel surface.
r_ using e Phillips screwdriver, remove the screws
from the handle.
rD] Insert the round button plugs into holes
on the hinge side of the door. NOTE: Be careful
not to scratch stainless steel.
r_ Place the door handle over the holes
on the handle side of the door. Attach
using the screws removed earlier.
r_ Insert the square button plugs over the handle
screws. NOTE: Be careful not to scratch
stainless steel or plastic surfaces.
I "L]L_
Button(" I II II
,
_..... :, i.]- Button Plugs _
13