GE PFIC1NFYCWV Owner's Manual And Installation Instructions page 11

About the automatic icemaker. GEAppliances.com
A newly installed refrigerator may take J2 to 2/4 hours to begin making ice.
Automatic Icemaker (on some models)
The icemaker will produce seven cubes
per cycle-approximately 100-1]0 cubes
in a 24-hour period, depending on freezer
compartment temperature, room
temperature, number of door openings
and other use conditions.
See below for how to access ice and reach
the power switch.
If the refrigerator is operated before the
water connection is made to the icemaker,
set the power switch in the 0 (offJposition.
When the refrigerator has been connected to
the water supply, set the power switch to the
I (on) position.The icemaker power light will
turn green when the freezer light switch is
pressed in or when the freezer door is closed.
The icemaker will fill with water when it cools
to 15°F(-10°C). A newly installedrefrigerator
may take 12 to 2/4hours to begin making ice
cubes.
You will hear a buzzing sound each time
the icemaker fills with water.
Throw away the first few batches of ice to
allow the water line to clear.
Be sure nothing interferes with the sweep
of the feeler arm.
When the bin fills to the level of the feeler
arm, the icemaker will stop producing ice.
It is normal for several cubes to be joined
together.
If ice is not used frequently, old ice cubes will
become cloudy, taste stale and shrink.
NOTE:In homes with lower-than-average
water pressure,_jou may hear the icemaker
qjcle multiple times when making one batch
of ice.
NOTE: Set the power switch to the 0 (off)
position if the water supply is shut off.
To reach the power switch.
Accessing Ice and Reaching
the Power Switch
To reach the icemaker power switch, pull
the shelf above the ice bin straight out.
Always be sure to replace the shelf.
To access ice, simply pull the bin forward.
Toaccessice.
Icemaker Accessory
Kit
If your refrigerator did not come already
equipped with an automatic icemaker,
an icemaker accessory kit is available at
extra cost.
Checkthe back of the refrigerator for the
specific icemaker kit needed for your model.
Y
Dispenser C radle
ii__ i
Spill Shelf
To Use the Dispenser
Pressthe glass gently against the top of the
dispenser cradle.
The spill shelf is not self-draining. To reduce
water spotting, the shelf should be cleaned
regularly.
If no water is dispensed when the refrigerator
is first installed,there may be air in the water
line system. Pressthe dispenser arm for at
least two minutes to remove trapped air from
the water line and to fill the water system. To
flush out impurities in the water line,throw
away the first six glassfuls of water.
Locking the Dispenser
Pressthe LOCKpad for ] seconds to lock
the dispenser and control panel.To unlock,
press and hold the pad again for ] seconds.
Door Alarm
To set the alarm, press the DOORALARM
pad. The indicator light will illuminate.
This alarm will sound if either door is
open for more than 2 minutes. The beeping
stops when you close the door.
11