Craftsman 320.16488 Operator's Manual page 39

APPLICATIONS
The stand can be used as a
stationary stand, a single roller
stand, or a multi-directional
roller stand.
• When using the stand as a
stationary stand, place the
steel bearings as shown in Fig.
6, and use the edge as a stop
for repetitive cuts.
• When using the stand as a
single roller stand, place the
steel bearings as shown
in Fig. 7.
• When using the stand as a
multi-directional roller stand,
position the steel bearings
above the roller (Fig. 8). The
steel bearings rotate 360°to
permit multi-directional
movement of workpiece.
Fig. 6
Steel --
bearings
Fig. 7
as an
edge guide
Fig. 8
16488 Manual_Revised_12 0604 Page 11