Table of Contents
Advertisement
Step 2
Installing the Roller (Fig. 3)
1.
Place the stand on a flat
surface.
Position
the roller (C)
onto the height-adjustment
bar (G). Use two screws (H),
two washers (J) and two nuts
(I) to mount the roller onto the
height-adjustment
bar (G) as
shown in Fig. 3.
2.
Hold the nuts (I) with the hex
key (supplied),
and tighten the
screws (H) with an open-end
wrench (not supplied)
(Fig. 4).
Step 3
Adjusting
Height (Fig. 5)
_,
WARNING:
Before using the
roller stand, check that all screws
and the locking
lever are
securely tightened.
1.
Loosen the locking lever by
turning
it counterclockwise.
2.
With one foot on the stand
foot, carefully
raise or lower
the roller, to the proper
position, according
to the
height of the worktable
of your
power tool (Fig. 5).
3.
Tighten the locking lever by
turning
it clockwise.
Fig. 3
C
I
Fig. 4
Fig. 5
!
Page 10
16488
ManuaLRevised_12
0604
Advertisement
Table of Contents
