Craftsman 137.248880 Operator's Manual page 2

SECTION PAGE
Warranty ........................................ 2
Product Specifications ....................... 2
Power Tool Safety ............................ 3
Table Saw Safety .............................. 4
Electrical Requirements and Safety ...... 5
Accessories and Attachments .............. 6
Tools Needed For Assembly ................ 6
Carton Contents .............................. 6
SECTION PAGE
Know Your Table Saw ....................... 8
Assembly and Adjustments ................. 9
Operation ....................................... 16
Maintenance ................................... 20
Troubleshooting Guide ....................... 21
Parts List ........................................ 22
Push Stick Pattern ........................... 30
FULL ONE YEAR WARRANTY
If this Table Saw fails due to a defect in material or workmanship within one year of date of purchase,
Sears will at its option repair or replace it free of charge.
Return this Table Saw to a Sears Service Center for repair, or to place of purchase for replacement.
This warranty gives you specific legal rights, and you may also have other rights which may vary from
state to state.
Sears, Roebuck and Co., Dept. 817 WA, Hoffman Estates, IL 60179
1_ WARNING I
Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains
chemicals known to the state of California to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• Lead from lead-based paints
° Crystalline silica from bricks, cement and other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals work in a well-ventilated area and work with approved safety equipmentsuch as
dust masks that are spec a y des gned to f ter out m croscop c part c es.
MOTOR
HP (Maximum developed) ..... 3.0
Type .................................. Universal
Amps ................................. 15
Voltage .............................. 120
Hz ...................................... 60
RPM (no load) .................... 5000
Overload Protection ............. YES
[A WARNING I
SAW
Table Size ........................ 26-7/64" x 19-1/2"
Table Extensions ............... Yes, with fences
Extension Fence Capacity... 24"
Right
and Left
Blade Size ........................ 10"
Rip Scale ......................... YES
Rip Fence ........................ YES
Miter Gauge ...................... YES
Maximum Cut Depth @ 90°.. 3"
Maximum Cut Depth @ 45°.. 2-1/2"
Maximum Dado Cut Width... 1/2"
Net Weight ...................... 64.5 LBS
To avoid electrical hazards, fire hazards or damage to the table saw, use proper circuit protection.
This table saw is wired at the factory for 110-120 Volt operation. It must be connected to a 110-120 Volt / 15
Ampere time delay fuse or circuit breaker. To avoid shock or fire, replace power cord immediately if it is worn,
cut or damaged in any way.
Before using your table saw, it is critical that you read and understand these safety rules. Failure to follow
these rules could result in serious injury to you or damage to the table saw.