Craftsman 351.217350 Operator's Manual page 4

INSTALL
DUST CHUTE
Refer to Figure 6.
• Slide dust chute over fan housing. Secure in position with
screw.
• Attach the Half Bag Dust Collection Set (included) only
after mounting planer to stand or workbench.
Figure 6 - Installing Dust Chute
MOUNT PLANER TO STAND
Refer to Figure 7.
CAUTION:
Planer weighs approximately 100 Ibs. Two people
may be required to lift planer.
* Planer is designed to be portable so it can be moved to
job site, but should be mounted to a stand or workbench
for stability.
* Make sure stand is located on a firm, level surface in a
place with ample lighting and correct power supply.
* Make sure there is plenty of room for moving the work-
piece through the entire cut. There must be enough room
that neither the operators or bystanders will have to stand
in line with the wood while using the tool.
. The base of the planer has four mounting holes, two in
front (shown in Figure 7) and two in the rear.
Figure 7 - Planer Mounting Holes (Front)
• Mount planer to workbench or tool stand (see Recom-
mended Accessories, page 17) using bolts, fiat washers
and hex nuts (not supplied).
• Figure 8 shows the base dimensions and mounting hole
dimensions of the planer.
3/e"
Dia.
113/8"
15"
25W'
Figure 8 - Base and Mounting Dimensions
-7
15"
INSTALL THE HALF BAG DUST COLLECTION SET
Refer to Figure 9.
The Craftsman Half Bag Dust Collection Set is designed
to provide dust collection for woodworking tools with a 2W'
diameter dust exhaust port. The filter bag attaches to a
30-gallon trash can or a 30-gallon x 1.3 mil plastic trash
bag for easy, convenient sawdust disposal (trash can and
plastic trash bag not included).
• Mount planer to stand before installing Dust Collection Set.
To use dust collection set with a trash can:
• Place spring inside filter bag arm.
• Slide arm with spring over dust chute.
• Place band of the bag over rim of trash can and secure
bag by tightening strap.
To use dust collection set with a trash bag:
• Place spring inside filter bag arm.
• Slide arm with spring over dust chute.
• Assemble bag support. Slide connectors into channels of
support segments.
• Slide plastic trash bag inside and over bag support. Let
bag overlap 3-4".
• Place band of the filter bag over and into the channel of
the bag support.
• Secure in position by tightening strap.
Spring ......... -_ Dust Chute
Support
Segments
Connector
_k_ __ Bag
P _O _ Support
Trash
Bag
Figure 9 - Half Bag Dust Collection Set
4