TROUBLESHOOTINGCHART
CAUSE
PROBLEM
Mower blades will not
rotate (Cont'n)
Poor grass discharge
Headlight(s)
not
working
(If so
equipped)
Battery will not charge
Engine "backfires"
when turning engine
"OFF"
• Frozen idler pulley.
• Frozen blade mandrel,
• Engine speed too slow.
position.
• Travel speed too fast.
• Wet grass.
mowing.
• Mower deck not level.
• Low/uneven
tire air
pressure.
• Worn, bent or loose blade.
Tighten blade bolt.
• Buildup of grass, leaves
and trash under mower.
• Mower drive belt worn.
• Blades improperly
installed.
• Improper blades used.
in this manual.
• Clogged
mower deck
vent holes from buildup
of grass, leaves, and
trash around mandrels.
• Switch is "OFP.
• Bulb(s)
burned out.
• Faulty light switch.
• Loose or damaged
wiring.
• Blown fuse.
• Bad battery cell(s).
• Poor cable connections.
• Faulty regulator (if so
equipped).
• Faulty altemator.
• Engine throttle control
not set at =SLOW"
position for 30 seconds
before stopping engine,
CORRECTION
° Replace idler pulley.
• Replace blade mandrel.
• Place throttle control in =FAST"
• Shift to slower speed.
• Allow grass to dry before
• Level mower deck.
• Check tires for proper air
pressure.
• Replace/sharpen blade.
• Clean underside of mower
housing.
• Replace
mower drive belt.
• Reinstall blades sharp edge
down.
• Replace
with blades listed
• Clean around mandrels to
open vent holes.
• Turn switch "ON'.
• Replace bulb(s).
• Check/replace
light switch.
• Check wiring and connections.
• Replace fuse.
• Replace battery.
• Check/clean
all connections.
• Replace
regulator.
• Replace
altemator.
• Move throttle control to
=SLOW" position and allow
to idle for 30 seconds before
stopping engine.
29