Download Print this page

Craftsman 536.797501 Operating Instructions Manual page 6

32.8 cc 2-cycle 10 inch diameter tines mini tiller/cultivator

Advertisement

Available languages

Available languages

Finger tighten only.
° Using two 7/16 inch wrenches, tighten
the Iocknuts on the screws in the lower
ends of the lower handles just enough to
hold the lower handles firmly in place
IMPORTANt; Overtighteningthe screws
enough to changethe shapeof the
handles can resultin damageto the en-
ginecasting.
• Hold the curved head carriage bolt
against the outside of the lower handle
while tightening the tee knobs securely.
TO INSTALL
THE THROTTLE
CONTROL
ASSEMBLY
• Place a Nov 10 x 1-1/2 inch hex head
screw down through the hole in the upper
handle right side and attach the throttle
control to the underside of the handle.
See figure Iower right.
• Attach the throttle cable to the right lower
handle by threading a tie strap through
the hole in the lower handle and around
the throttle cable on the outside of the
handle.
• Thread the pointed end of the strap
through the other (square) end of the
strap and pull tight around the throttle
cable and lower handle,
NOTE; One side of thetie strap is rough,
whiletheotherside is smooth. T he rough
side must be on the insideof the loop
formed whenthe endsofthetie strapare
puttogether.
• Try to loosen the tie strap_ If it will loosen,
it has been put together incorrectly with
the smooth side to the inside of the loop
Remove the tie strap and reverse the
direction°
• Cut off excess strap,
/
CHECKLIST
Before you operate and enjoy your new
MINI TILLER/CULTIVATOR, we to ensure
that you receive the best performance and
satisfactionfrom this quality product, please
review the following checklist:
/
All assembly instructions have been
completed.
/
No remaining loose parts in carton.
All fasteners have been properly
installed and tightened,
Whilelearning howto useyourMINI
TILLER/CULTIVATOR, pay extraattention
tothe following important i tems:
/4' Fueltankisfilled withcorrectgasoline
andoilmixture°
/4' Become fami!_ar withthe location and
function of allcontrols_ O perate
controls beforestarting engine.
11/32 Inch
No. 10 X t-1t2
Flatwasher
_-_\_
Hex Nut
Car age Bolt
3"ie_ ,rap _fk \
P& r
Handle

Advertisement

loading