Advertisement
Available languages
Available languages
TINE REPLACEMENT
The mini tillerlcultivator is left hand or right
hand as viewed from the operator's position
behind the unit.
All four tines on this unit are different and
cannot be interchanged..The tines must be
properly installed as shown in figures to the
right or the mini tiller/cultivator will not func-
tion properly,,
For working close around plants or in small
areas, the OLrlsidetines may be removed to
reduce the tilling width to about 7 inches. To
reinstall the outside tines see below.
CAUTION:
The tines are sell sharp+
ening and wilt become quite sharp from
use. Handle carefully_
The tines will all wear fairly evenly° ti the
tines are being replaced because of wear,
we recommend that all four tines be re-
placed at the same time. To replace the
tines, do the following:
. Place the shut-off switch to the OFF
position and disconnect the spark plug
wire.
• Remove the hairpins and the clevis pins
from the tines on one side of the unit and
then remove the tines., See figure,
previous page+
o Clean the line shaft and oit it at the line
locations.
o Place the inside line on the tine shaft and
reinstall the clevis pin and hairpin_
• When the tines are properly installed,the
letter R will be visible on the outside of
the right+handtine (the letter L on the left.
hand tine)_ The letter should appear
opposite the small hole in the side of the
t|ne°
• Place the outside tine on the tine shaft
and reinstall the clevis pin and hairpino
° The outside tine cutting tips will all bend
in toward the inside tine_The letter R on
the right side or L on the left side shouid
be visible from the outside of the unit°
• Repeat the above steps on the opposite
side of the unit.
° Check to make sure the tines are
installed on correct side of the unit
Properly installed Right Side_nes
Right Side Indicator
CARBURETOR
ADJUSTMENT
A dirty air cleaner will cause the engine to
run improperlyand/or smoke excessively._
Be sure the air cleaner is clean before ad-
justing the carburetor° Never make unnec+
essary adjustments to the carburetor+The
carburetor was set at the factory to operate
efficiently under most applications+How-
ever, if adjustments are required, we recom-
mend you contact your nearest Sears Ser-
vice Center,, If you feel that you are qompe+
tent to make carburetor adjustment proceed
as follows:
m_a CAUTION: Use extreme care when
ing adjustments that require the engine
to be running, Keep hands, feet, hair and
loose clothing away from any moving part
, Turn the mixture adjustment screw
clockwise to close.
IMPORTANT:
Tighten the adjusting
screw with your fingers to prevent dam-
age to the carburetor or adjusting screw..
• Turn the mixture screw counterclockwise
open one (t) turn+
• Start the engine and let it warm up
approximately3 to 5 minutes+ Do not
adjust the carburetor when the engine is
cold+
• If the engine falters or stops after the
choke lever is moved to the OFF position,
open the mixture adjusting screw an
additional t/8 turn countemlockwise.
• With the engine running, release the
throttle control (idle position) to make the
mixture adjustments. Then perform the
following:
t3
Advertisement
