Advertisement
Operating
and Replacing
the Oven Light
The interior oven light wilt The oven interior light will automatically turn on when the oven door is opened. Press _
to turn
the light ON and OFF when the oven door is closed. The oven light is located at the rear wall of the oven interior and is covered
with a glass shield held by a wire holder. The glass shield must be in place whenever the oven is in use.
Wire
Holder
Figure 1
Be sure the range is unplugged and all parts are COOL
before replacing the oven light. Wear a leather-faced
glove for
protection against possible broken glass.
To
Replace
the Oven
Light:
1.
Turn electrical power off at the main source and unplug the range.
2.
Press wire holder to one side to release glass shield (See Fig. 1).
3.
Replace the old bulb with a new 40 watt appliance bulb.
4.
Replace glass shield over bulb and snap wire holder into place.
5.
Turn power back on again at the main source (or plug in the range).
6.
The clock wilt then need to be reset. To reset, see Setting the Clock
in this Use & Care Manual.
or
a Nail
Figure 2
Figure 3
Hinge
Figure 4
Removing
and Replacing
the Oven
Door
(all models)
The door is heavy. For safe, temporary storage, lay the door flat with
the inside of the door facing down.
To Remove Oven Door:
1.
Open oven door completely (horizontal with floor-
See Fig. 2).
2.
Remove 2 screws located on the inside of the oven door liner (See A Fig. 3).
3.
Insert the 2 screws into the door hinge holes located on the side of the hinge
arm, one into each hinge (See B Fig. 3).
4.
Close oven door until the door stops, (Do not force the door to close anyfurther).
The placement of these screws should keep door open in about a 45 degree
position.
5.
Graspovendoorfirmlyonbothsidesandslidedoorupandoffhingesatthesame
angle. (See Fig. 4)
6.
To ctean oven door, follow the instructions provided in the Cteaning Chart at the
beginning of the Care & Cleaning section (See Door Liner).
To Replace Oven Door:
1.
Be sure the hinge arms remain at the 45 degree angle position. Be sure the
screws are still locking the hinge arms from moving. If the screws fall out of
the hinge holes, the hinge(s) may snap back against the oven frame and could
pinch fingers or chip the porcelain finish on the oven front frame.
2.
Hold door at the sides near the top while resting the lower front of door on your
knee. Insert the door channels at the bottom of door over the door hinges, (See
Fig. 4).
3.
Allow the door to slide down into the door hinges evenly at the same 45 degree
angle. The hinge arms should be inserted into the bottom corners as far as they
can go.
4.
Open door completely
(horizontal with floor) and remove both screws from
holes in door hinges.
5.
Reinstall the 2 screws into the door liner (See C Fig. 3).
6.
If the door is not in alignment with the oven frame, remove door and repeat the
above steps.
31
Advertisement
